Manual Hotpoint CS1A 400 FM H (UK) Freezer

Manual

INSTRUCTIONS FOR USE

EN

APPLIANCE DIAGRAM (Fig. 1)

A. Handle.

B. Safety closure (if provided).

C. Seal.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor ventilation grille.

CONTROL PANEL DIAGRAM (Fig. 2)

1. Red light: when blinking, it indicates an alarm condition

(see the section “TROUBLESHOOTING GUIDE”).

2. Blue light: when on, it indicates that the FROST GUARD

function is activated (see the section “FROST GUARD

FUNCTION”)

3. Green lights: they indicate that the product is working,

the set temperature and possible activation of the quick

freeze function (“Super Freeze”).

4. Setting button: for updating the set temperature, activation/

deactivation of the quick freeze function (“Super Freeze”) and

activation/deactivation of the “FROST GUARD” function.

BEFORE USING THE APPLIANCE

Your new appliance is designed to be used in the

household and similar applications such as:

- kitchen areas in shops, oces and other working

environments

- farm houses

- by clients in hotels, motels, residences, bed &

breakfasts.

The product must only be used to store frozen food, to

freeze fresh food and to make ice.

Regulations require the appliance to be earthed. The

manufacturer declines all liability for injury to persons

or animals and for damage to property resulting from

failure to observe the above procedures and reminders.

1. After unpacking, make sure that the appliance is

undamaged and that the door closes perfectly, with the

gasket remaining intact. Any damage must be reported to

your retailer within 24 hours after delivery of the appliance.

2. Wait at least two hours before switching the appliance on

in order to ensure the refrigerant circuit is fully ecient.

3. Installation and electrical connection must be carried out

by a qualied technician, according to the manufacturer’s

instructions and local safety regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains supply,

ensure that the voltage corresponds to that given on the

rating plate located on the rear of the appliance.

• Electrical connections must be made in accordance

with local regulations.

INSTALLATION

• Unpack the product.

• Remove the 4 spacers inserted between the lid and

the product. (Fig. 3)

• Make sure the defrost water drain plug (if provided) is

correctly positioned (E).

• For optimum operation and to avoid damage when the

lid is opened, maintain a distance of at least 7 cm from

the front wall and 7 cm at the sides. (Fig. 4)

• Insert the accessories (if provided).

STARTING THE PRODUCT

• Connect the product to the power supply.

• The green light (“Normal”) comes on.

• The red light (1) blinks, since the temperature inside the

product is not yet low enough for loading food. This light

normally goes o within six hours after startup.

• Place food inside only when the red light has gone o.

Note: If the FROST GUARD function is deactivated, the lid

cannot be immediately reopened after closing it, because

the seal is tight. It is necessary to wait a few minutes before

reopening the lid.

TEMPERATURE ADJUSTMENT

Use the button (4) to select the required temperature. To

adjust the product temperature, proceed as follows:

• Press the button (4). With each press of the button, the

set temperature will be changed cyclically between the

values “Eco”, “Normal”, “Intensive” and “Super Freeze”.

• Select “Intensive” for a colder storage temperature.

• In case of a partial load, it is advisable to select “Eco” to

optimise energy consumption.

The green lights (3) indicate the selected setting as follows:

Eco: less cold temperature

(left light on).

Normal: middle temperature

(right light on).

Intensive: very cold temperature

(both lights on).

Super Freeze: Quick Freeze

(both lights on blinking).

See the section “Freezing fresh food”.

Note: In case of a power failure, the settings (except for

the “FROST GUARD” function) remain stored. The time

required for the temperature inside the freezer to reach

approximately the set value may vary depending on the

climatic conditions and the setting selected.

FROST GUARD FUNCTION

The FROST GUARD function signicantly reduces the

amount of frost that can form inside the product, collecting

it in the special easy to remove and clean “ICE BOX” (M)

container. FROST GUARD technology also allows

easy reopening of the lid at any time whenever deemed

necessary, even repeatedly, always with the same eort.

The FROST GUARD function is already activated when the

product is switched on the rst time (blue light on). It can be

deactivated/reactivated by keeping the button (4) pressed

for at least 3 seconds.

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Hotpoint CS1A 400 FM H (UK) Freezer. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Hotpoint. They might be able to provide an original manual. Are you looking for the manual of your Hotpoint CS1A 400 FM H (UK) Freezer in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Hotpoint Freezers
More manuals of Freezers

Frequently Asked Questions about Hotpoint CS1A 400 FM H (UK) Freezer

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Hotpoint HF 1801 E F AA.UK.1 Freezer

Manual

Hotpoint CS1A 300 H UK Freezer

Manual

Hotpoint UH6 1T X.1 Freezer

Manual

Hotpoint UH8 F1C G UK Freezer

Manual

Hotpoint BFS 1222.1 Freezer

Manual

Hotpoint FZA36G.1 Freezer

Manual

Hotpoint UH8 F1C W UK.1 Freezer

Manual

Hotpoint BF 3022 NF Freezer

Related categories