Manual Westinghouse WFE614SC Range

Manual

13BEFORE OPERATING12 TESTING

TESTING THE OPERATION OF

THE GAS COOKER

NOTE: You MUST test the cooker after installation, before

you hand it over to the customer.

You MUST have a manometer and a connecting tube.

Checking gas supply

1. Check the manometer zero point is correct.

2. Connect the manometer to the cooker pressure

test point. This is located on the regulator or LPG/

Propane inlet fitting.

3. Turn on the gas supply and the electricity and try to

ignite the gas.

NOTE: It will take additional time to light the gas for

the first time as air needs to be purged from

the pipes.

4. Check the operating pressure for the particular

gas type. For details, see “Connections” on page 11.

NOTE: For LPG/Propane cookers: Adjust the regulator if

necessary (this may be remote from the cooker).

For Natural Gas cookers

Regulators are supplied pre-adjusted and configured

by the component maker for use with Natural Gas. The

appliance installer is not required to make an adjustment

to obtain the correct outlet pressure setting.

An arrow on the base of the regulator indicates the

direction of gas flow when the inlet and outlet of the

regulator are orientated correctly. When the regulator

has been fitted check for leaks from the connections

with soapy water.

Checking the Function of the Regulator

With the appliance operating check the outlet pressure:

• When all burners of the appliance are operating

at maximum,

• When the smallest burner of the appliance is

operating at minimum.

Under these conditions the outlet pressure should not

vary from the nominal outlet pressure by more than

±20% of the nominal outlet pressure (ie ±0.20kPa for

Natural Gas).

If the regulator appears to not be performing

satisfactorily then check the following points.

1. If the outlet pressure is consistently too low then the

inlet pressure may be too low and adjustment of an

upstream regulator may be needed, or an upstream

regulator or valve with insufficient flow capacity may

be present in the gas supply line. If this is suspected

then it may be necessary to repeat the checks whilst

measuring both the inlet and outlet pressure to

determine if the inlet pressure is in the range

1.13 – 5kPa.

2. Check that the regulator has been fitted to the gas

supply line in the correct orientation, the arrow on the

base of the body indicates the direction of gas flow.

Once these checks have been completed, if the regulator

still fails to perform in a satisfactory manner it should

be replaced.

Testing the cooker features

• Observe the flame appearance on each burner. If it

is much smaller or larger than expected, then the

injector size needs checking.

NOTE: When flame is unsatisfactory, then refer to the

Electrolux Technical Publications and correct the fault, if

possible.

When maximum flame appearance is correct, then check

the turn-down setting on each burner. If the settings

appear to be incorrect, proceed as follows:

1. Adjust the bypass screw mounted on the body of

each hotplate control cock. This is accessible when

the control knob is removed.

2. Check the ignition on all burners both separately

and in combination.

3. Check the operation of the electrical components,

if applicable.

4. If you are satisfied that the cooker is operating

correctly, then turn it off and show the customer

how to use it. Make sure you ask the customer to

operate the controls.

NOTE: If the cooker cannot be adjusted to perform

correctly, then inform the customer of the problem and

put a warning notice on the cooker. If the problem is

dangerous, then disconnect the cooker. If there is a fault,

then the customer should be advised to contact the

manufacturer’s local service organisation or the retailer.

Fitting the grill dish (WFE532 only)

Separate Grill: Ensure rear of the dish is engaged with

the side support before sliding backwards. To remove,

simply

pull forwards and upwards.

To ensure proper grill operation, slide the grill dish fully

rearward to the stop.

To remove, simply pull forwards and upwards.

Engagement

of rear of dish

Air Fry (For WFE616 and WFE646 only)

The Air Fry fits into the oven supports (side runners)

just as shelves

Grill in oven

(refer to Fitting Oven Shelves)

The grill dish with wire insert can be used in any of the

two upper height positions (shelf positions 4 and 5)

between the runners.

NOTE: You must remove the grill dish when baking in

the oven.

Grill dish

insertion

Grill dish

final position

Preparing your appliance for the first time

• Please remove all internal boxes and bags from the

oven before operation.

• Please wipe out the oven interior prior to operation

with warm soapy water and polish dry with a soft

clean cloth. Do not close the oven door until the oven

is completely dry.

WARNING

CAUTION

• Do not line the oven with foil as it will damage

the enamel.

• New appliances can have an odour during first use. It

is recommended to ‘run in’ the oven before cooking

for the first time Operate the oven(s), empty, at a

temperature of 180°C for approximately 30 minutes.

For appliances with a separate grill, run the grill on

maximum for 15 minutes WITH GRILL DOOR OPEN

Please ensure that the room is well ventilated during

this process.

Installing your oven accessories

Fitting oven shelves

1. Ensure shelf orientation is correct (refer to diagram

below).

2. Slide oven shelves onto oven supports (side runners)

at an angle until raised back of shelf is past the stop

on oven supports (side runners).

3. Lower front of shelf and push in until stop is reached.

4. To remove oven shelves, withdraw to the stop and

raise the front of shelf to clear the stop.

Note the orientation of the side

and rear features

BEFORE OPERATING YOUR APPLIANCE FOR THE FIRST TIME

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Westinghouse WFE614SC Range. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Westinghouse. They might be able to provide an original manual. Are you looking for the manual of your Westinghouse WFE614SC Range in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Westinghouse Ranges
More manuals of Ranges

Frequently Asked Questions about Westinghouse WFE614SC Range

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Westinghouse WFE946SA Range

Manual

Westinghouse 4U600W Range

Manual

Westinghouse 4U612W Range

Manual

Westinghouse WFE915SD Range

Manual

Westinghouse WLE533WA Range

Manual

Westinghouse WFE612SC Range

Manual

Westinghouse DSP635S Range

Manual

Westinghouse WFG617 Range

Related categories