Home > Household appliances > Ranges > Westinghouse Ranges > Westinghouse WDG112WC Range

Manual Westinghouse WDG112WC Range

Need a manual for your Westinghouse WDG112WC Range? Below you can view and download the PDF manual for free in English. This product currently has 8 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

13OPERATING FOR THE FIRST TIME

OPERATING FOR THE FIRST TIME

Installation and Service Warning

WARNING

• Only an authorised person must install and

service this appliance (Certificate of Compliance

to be retained).

• In order to avoid a hazard, the installation instructions

MUST be followed.

• In order to avoid the appliance tipping, the anti-tilt

plate MUST be installed.

• Appliances requiring connection to 230 – 240V MUST

be earthed.

• An authorised person should inspect this appliance

every 5 years.

• If the electrical supply cord is damaged, a qualified

person MUST replace the cord to avoid a hazard or

void your warranty.

WARNING

Surrounding kitchen cabinets MUST WITHSTAND 85°C.

TIPS & INFORMATION

Setting the time

1. If you have purchased a model fitted with a 3 button

programmable timer, you must set the time of day

before you can operate your appliance.

• After the appliance has been electrically connected

‘12.00’ will be displayed and the ‘clock indicator’ will

flash.

• To set the time of day, press the – or + buttons. 5

seconds after the last change, the ‘clock’ indicator

will disappear, confirming the time has been set.

NOTE: The clock has a 24-hour display.

2. New appliances can have an odour during first

operation. It is recommended to ‘run in’ the oven

before you cook Run the oven at 180°C for 30

minutes and ensure that the room is well ventilated.

For products with a separate grill compartment, run

grill on maximum for 15 minutes with grill door open.

If your appliance is fitted with solid hotplates, turn

heat setting to high for 3 minutes to fully harden the

hotplate coating.

TIPS & INFORMATION

Before operating first time

1. Read all the Warning and Safety information.

Remove all internal boxes and bags from oven.

Clean out the oven interior with detergent and warm

water and polish with a soft cloth. DO NOT close

oven door until the oven is completely dry.

12 INSTALLING THE GAS ELEVATED COOKER

Testing Burner Performance

• Observe the flame appearance on each burner when

set to max. If it is smaller or larger than expected,

then the injector size needs checking (refer to table).

• When maximum flame appearance is correct, check

the turn down setting on each burner. If incorrect,

proceed as follows:

WARNING

Disconnect electric power.

1. Remove the control panel and adjust the bypass

screw when valve is set to maximum. The screw is

mounted on the body of each hotplate control valve.

2. Check the ignition on all burners both separately and

in combination.

3. Check the operation of the electrical components,

if applicable.

4. When operating correctly, show customer how to use

the cooker.

5. If not operating correctly, advise the customer to ring

Electrolux Customer Service Centre. Place a warning

sign on cooker or if dangerous, disconnect cooker.

Checking the gas supply

1. Check the manometer zero point is correct.

2. Connect the manometer to the cooker pressure

test point. This is located on the regulator or LPG

inlet fitting.

3. Turn on the gas supply and the electricity (if

applicable) and try to ignite the gas.

NOTE: It will take additional time to light the gas for the

first time, as air needs to be purged from the pipes.

4. Check the operating pressure for the particular gas

type (see ‘Gas Type’ table).

• For LPG cookers: Adjust the regulator if

necessary (this may be remote from the cooker).

• For Natural Gas cookers: Regulators are supplied

pre-adjusted and configured by the component

maker for use with Natural Gas. The appliance

installer is not required to make an adjustment

to obtain the correct outlet pressure setting.

An arrow on the base of the regulator indicates

the direction of the gas flow when the inlet and

outlet of the regulator are orientated correctly.

5. When the regulator has been fitted check for leaks

from the connections with soapy water.

Checking regulator function

With the appliance operating, check the outlet pressure:

1. When all the burners of the appliance are operating

at maximum.

2. When the smallest burner of the appliance is

operating at minimum.

Under both these conditions the outlet pressure

should not vary from nominal operating pressure

of 1.0kPa by more then ± 20% (ie ±0.20kPa for

Natural Gas).

If the regulator does not appear to be performing

satisfactorily then check the following points:

1. If the outlet pressure is consistently too low then

• the inlet pressure may be too low and

adjustment of an upstream regulator may be

needed, or

• an upstream regulator or valve with insufficient

flow capacity may be present in the gas supply

line. It may be necessary to repeat the checks

whilst measuring both the inlet and outlet

pressure to determine if the inlet pressure is in

the range 1.13-5kPa.

2. Check that the regulator has been fitted to the gas

supply line in the correct orientation.

3. Replace the regulator if it fails to perform after

the checks.

INSTALLING THE GAS ELEVATED COOKER

Rating

Let us know what you think about the Westinghouse WDG112WC Range by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the Westinghouse WDG112WC Range?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the Westinghouse WDG112WC Range. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Westinghouse WDG112WC Range. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Westinghouse. They might be able to provide an original manual. Are you looking for the manual of your Westinghouse WDG112WC Range in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand	Westinghouse
Model	WDG112WC
Category	Ranges
File type	PDF
File size	2.23 MB

All manuals for Westinghouse Ranges
More manuals of Ranges

Frequently Asked Questions about Westinghouse WDG112WC Range

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Why does the ignition on my range make a clicking sound? Verified

If the range has ben cleaned with a lot of water, the knobs might have gotten wet, triggering the ignition. Let the knobs dry. If the problem persists you should contact the manufacturer.

This was helpful (1092) Read more

The oven in my range does not get warm enough, what should I do? Verified

The thermostat makes sure the ovens heats up to the designated temperature. It is likely that the thermostat is defective. Have it replaced. When in doubt, contact the manufacturer.

This was helpful (1066) Read more

Which pans can be used on an induction range? Verified

In general all pans that are magnetic can be used on an induction range. Almost all new pans are suited for induction.

This was helpful (863) Read more

My range has a power plug that doesn't fit a regular socket, what should I do? Verified

Many electric ranges (both ceramic and induction) have a different plug. This is because these appliances require a lot of power. Have the installation of the appliance done by a professional.

This was helpful (471) Read more

What is pyrolysis? Verified

Some ovens are equipped with a pyrolysis function. This is a cleaning system that burns dirt and fat in the oven by using very high temperatures. After pyrolysis, all the dirt will have turned to ash and can be easily removed. If the oven has a pyrolysis function, it is advisable to use it 3 to 4 times a year to keep the oven clean.

This was helpful (406) Read more

Can I connect a range to an extension cord? Verified

Appliances that require large amounts of power, like a range, can not be connected to all extension cords. See what the power usage of the range is, which is indicated in Watt, and check if the extension cord can handle this. There are extension cords with thicker cables that are made to handle larger appliances.

This was helpful (209) Read more

When I use the oven there often food remains that fall on the bottom, causing smoke. How can I prevent this? Verified

Many ovens come with both a grid and a baking tray. When food is prepared on the grid, the baking tray can be placed on the bottom to prevent food remains from burning and causing smoke.

This was helpful (197) Read more

Can I prepare several items simultaneously by using more grill trays? Verified

Technically this is possible. However, it depends on the type of food if you need to adjust the preparation time or swap the trays halfway during the preparation.

This was helpful (195) Read more