Home > Camping & Outdoor > Tents > Vango Tents > Vango Hop 300 Tent

Manual Vango Hop 300 Tent

Need a manual for your Vango Hop 300 Tent? Below you can view and download the PDF manual for free in English. This product currently has 7 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

TENT PITCHING INSTRUCTIONS – HOP (UK)

Inner First Pitching

1. Assemble poles and lay them parallel on the ground (2 poles – 1 long, 1 short).

2. Open out inner and position in required direction.

3. Insert the poles through the pole sleeves on the outside of the inner.

4. Locate one end of each pole on one side of inner into the metal pin system at the end of the pole sleeves. Push poles into an arch

from opposite ends and locate pole ends into corresponding metal pin.

5. Peg the rear point of the inner tent.

6. Carefully extend the tent forwards, then peg the two front corners.

7. Peg both of the poles through the ring of the ring and pin system.

Flysheet

1. Open out flysheet and position so that the inner doorway and the flysheet doorway correspond.

2. A number of connectors are located on the underside of the flysheet. These must be secured around the poles of the inner tent.

3. Peg down each side of flysheet through the shock-cord pegging points, adjacent to the metal rings of the inner tent.

4. Pull porch taut, away from main body of tent and peg down the corners of the porch through the shock-cord pegging points using pin-

pegs.

5. Peg out the rear point of the flysheet.

6. Peg out ALL guy lines using pin-pegs ensuring that guy line fabric attachment points are evenly tensioned.

……………………………………………………………………………………………………………………………………………………………………………………………………………

AUFBAUANLEITUNG – HOP (DE)

Innenzelt-zuerst-Aufbau

1. Stecken Sie die Stangen zusammen und legen Sie sie parallel zueinander auf den Boden (2 Stangen - 1 lange, 1 kurze).

2. Breiten Sie das Innenzelt aus und positionieren Sie es in der gewünschten Richtung.

3. Führen Sie die Stangen durch die Stangenhüllen an der Außenseite des Innenzelts ein.

4. Fixieren Sie ein Ende jeder Stange an einer Seite des Innenzelts im Metallstift-System am Ende der Stangenhüllen. Drücken Sie die

Stangen gewölbeförmig von den entgegengesetzten Enden aus hoch und fixieren Sie die Stangenenden mit den passenden

Metallstiften.

5. Befestigen Sie das hintere Ende des Innenzelts.

6. Ziehen Sie das Zelt vorsichtig nach vorne, befestigen Sie dann die beiden vorderen Ecken.

7. Stecken Sie beide Stangen durch den Ring des Ring-und-Stift-Systems.

Außenzelt

1. Außenzelt ausfalten und so ausrichten, dass Inneneingang und Außenzelteingang übereinstimmen.

2. An den Unterseite des Außenzelts befinden sich eine Reihe von Verschlussstreifen. Diese müssen um die Stangen des Innenzelts

befestigt werden.

3. Befestigen Sie jede Seite des Außenzelts durch die mit Gummizug versehenen Befestigungspunkte, die sich neben den Metallringen

des Innenzelts befinden. Verwenden Sie die mitgelieferten Stiftheringe.

4. Ziehen Sie den Vorbau straff und vom Hauptzelt weg und fixieren Sie die Ecken des Vorbaus durch die mit Gummizug ausgestatteten

Befestigungspunkte mit Stiftheringen.

5. Stecken Sie das hintere Ende des Außenzelts aus.

6. Stecken Sie alle Spannschnüre mit den mitgelieferten Heringen aus und stellen Sie sicher, dass die Befestigungspunkte der

Spannschnüre gleichmäßig unter Spannung sind.

INSTRUCTIONS DE MONTAGE – HOP (FR)

Montage en commençant par la tente intérieure

1. Réunir les arceaux et les poser parallèlement au sol (2 arceaux – 1 long, 1 court).

2. Ouvrir la tente intérieure et la positionner dans la direction voulue.

3. Insérer les arceaux dans les fourreaux d'arceau, à l'extérieur de la tente intérieure.

4. Placer une extrémité de chaque arceau sur un côté intérieur, dans le système de verrouillage en métal, à l'extrémité des fourreaux

d'arceau. Pousser les arceaux à l'intérieur d'une arche, depuis les extrémités opposées, et placer les extrémités de l'arceau à l'intérieur

de la cheville métallique correspondante.

5. Attacher le point de fixation arrière de la tente intérieure.

6. Etendre soigneusement la tente vers l'avant, puis fixer les deux coins de devant.

7. Fixer deux des arceaux, en les introduisant dans l'anneau du système de verrouillage ring & pin.

Double Toit

1. Déferler le double toit et l'orienter de sorte que la porte intérieure et celle du double toit 'se correspondent'

2. Une quantité de bandes se trouvent au dessous du tapis de sol, elles doivent s'attacher aux mâts de la tente intérieure

3. Piqueter chaque bord du double toit par les points indiqués au cordon de serrage, proches des anneaux de la tente intérieure. Se servir

des piquets fournis

4. Tensionner l'extension en l'éloignant du reste de la tente, et attacher les coins en plantant des piquets par les points d'ancrage du

cordon de serrage

5. Attacher le point de fixation arrière du double toit.

6. Attacher toutes les cordes de tension à l'aides des piquets fournis, en s'assurant que les points d'attache des cordes de tension sont

uniformément tendus.

Rating

Let us know what you think about the Vango Hop 300 Tent by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the Vango Hop 300 Tent?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the Vango Hop 300 Tent. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Vango Hop 300 Tent. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Vango. They might be able to provide an original manual. Are you looking for the manual of your Vango Hop 300 Tent in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand	Vango
Model	Hop 300
Category	Tents
File type	PDF
File size	0.26 MB

All manuals for Vango Tents
More manuals of Tents

Frequently Asked Questions about Vango Hop 300 Tent

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Can I store my tent when it's wet? Verified

Only for very short periods of time. When a tent is stored while wet for a week or longer, it can get moldy. This is harmful for your tent and possibly your health.

This was helpful (384) Read more

How do I impregnate a tent? Verified

Pitch the tent, clean the cloth and let it dry. Apply the impregnation agent on the cloth with a plant sprayer or other spray. It is also possible to use a paint roller or brush. The cloth needs to be fully saturated with the impregnation agent. Also treat the inside of the tent. Thoroughly clean any windows with a moist cloth. Do not let the impregnation agent dry on it. Let the tent cloth fully dry. Repeat the treatment if needed.

This was helpful (285) Read more

Can I repair a tear or hole in the canvas of my tent myself? Verified

There are special pieces of self-adhesive patches of cloth available for synthetic tent canvases. Stick one of these patches on both sides of the hole or tear. For cotton tent canvases or mixed material tent canvases it's best to use patches that can be ironed on. This will require an iron.

This was helpful (218) Read more

The zipper of my tent won't run smoothly, what can I do? Verified

When a zipper is running smoothly, use a dry PTFE spray or silicone spray. Do not spray onto the cloth and preventively spray to prevent future problems.

This was helpful (156) Read more

There are water drops on the inside of the tent, does this mean it is leaking? Verified

No, this is probably condensation. Make sure the tent is properly ventilated to keep condensation at a minimum.

This was helpful (129) Read more

What tent pegs are best to use for which surfaces? Verified

On grassland or forest surfaces you can use semi circular or plastic pegs. On rocky surfaces you need to use rock pegs. On clay surfaces you can use semi circular, plastic or universal pegs. On gravel surfaces you need semi circular or universal pegs and on sand you need to use wooden pegs.

This was helpful (105) Read more

The impregnation agent leaves white stains or a white haze on the tent cloth, what can I do about this? Verified

If the agent leaves a white haze or white stains on the tent cloth, this means you have applied more impregnation agent on those areas. This is not harmful and the stains often disappear over time. It is not advisable to use less impregnation agent to prevent stains. The cloth needs to be fully saturated with the impregnation agent to give good results.

This was helpful (97) Read more