Manual Samsung MAX-900 CD Player

Manual

GB

5

GB

4

The AM aerial (for long and medium waves) can be:

Placed on a stable surface

Fixed to the wall

The AM aerial connector terminals are located on the rear of the system and

are marked AM.

To avoid noise interference, check that the loudspeaker wires do

not run close to the aerial wires.

Always keep them at least 2 inches (5 cm) away.

There are two types of aerial, (depending on option chosen).

How to connect a COAXIAL TYPE aerial.

Connect a 75Ω antenna to the FM antenna terminal.

Plug the connector on the FM aerial supplied into the coaxial socket

(75Ω) marked FM on the rear of the system.

Follow the instructions given on Page 10 to tune into a radio station,

and determine the best position for the aerial.

If reception is poor, you may need to install an outdoor aerial.

To do so, connect an outdoor FM aerial to the FM socket on the rear

of the system using a 75Ω coaxial cable (not supplied).

How to connect a SCREW TYPE aerial.

The FM aerial connector terminals are located on the rear of the

system and marked FM (75Ω).

Spread the T.form FM aerial out and attach the ends to a wall,

in the position providing the best reception.

How to connect a WIRE TYPE aerial.

Spread the SW aerial out and attach the ends to a wall, in the position

providing the best reception.

If reception is poor (e.g. distance from transmitter too great, walls

blocking the radio waves, etc.), install an outdoor aerial.

Connecting the AM (MW) Aerial

Connecting the FM Aerial

Connecting the SW Aerial (option)

1

1

2

FM FM

FM AERIAL

(supplied)

75Ω COAXIAL CABLE

(not supplied)

To take full advantage of your new mini-compact system, follow

these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 4 inches (10 cm) on the

sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc

compartment easily.

Place the loudspeakers at a reasonable distance on either side of

the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed

at an equal distance above the floor.

Insert or replace remote control batteries when you:

Purchase the mini-compact system

Find that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and

never mix alkaline and manganese batteries.

Place your thumb on the position marked on the battery compartment

cover (rear of the remote control) and push the cover in the direction of

the arrow.

Insert two AAA, LR03 or equivalent batteries, taking care to respect

the polarities:

+ on the battery against + on the remote control

– on the battery against - on the remote control

Replace the cover by sliding it back until it clicks into position.

The loudspeaker connector terminals are located on the rear

of the system.

There are four terminals on the system:

Two for the left speaker (marked L)

Two for the right speaker (marked R)

To achieve the correct sound quality, connect the:

Red wire to the + terminals

Black wire to the - terminals

To connect a wire to a terminal, push the tab as far as it will go:

To the right on the system

Insert the wire, up to the plastic sheathing, in the hole.

Push the tab back:

To the left on the system, until it clicks into place

Result:

The wire is pinched and held firmly in place.

Repeat the operation for each wire.

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check

the voltage setting (OPTIONAL). If the voltage of the socket does

not correspond to the setting on the rear of the unit, you may

seriously damage your system.

Check the position of the voltage selector on the rear of the system

(OPTIONAL).

Plug the main lead (marked AC CORD on the rear of the system) into

an appropriate socket.

Press the POWER button to switch your mini-component system on.

Where to Install Your

Mini-Compact System

Inserting Remote Control Batteries

Connecting the Loudspeakers

Connecting Your System to the

Power Supply

1

2

3

option

1

2

3

4

1

2

3

(IMPEDANCE 4Ω)

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Samsung MAX-900 CD Player. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Samsung. They might be able to provide an original manual. Are you looking for the manual of your Samsung MAX-900 CD Player in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Samsung CD Players
More manuals of CD Players

Frequently Asked Questions about Samsung MAX-900 CD Player

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Samsung MAX-B550 CD Player

Manual

Samsung MAX-S720 CD Player

Manual

Samsung MAX-DG56 CD Player

Manual

Samsung MAX-DN87 CD Player

Manual

Samsung MAX-G55 CD Player

Manual

Samsung MX-J630 CD Player

Manual

Samsung MAX-ZJ650 CD Player

Manual

Samsung MAX-ZJ550 CD Player

Related categories