Manual Philips S321 Shaver

Manual

- Do not use the appliance in the bath

or in the shower.

- Never use water hotter than 60°C to

rinse the shaver.

- Do not use the appliance, adapter or

any other part if it is damaged, as this

may cause injury. Always replace a

damaged adapter or part with one of

the original type.

- Never use compressed air, scouring

pads, abrasive cleaning agents or

aggressive liquids such as petrol or

acetone to clean the appliance.

- Water may drip from the socket at the

bottom of the shaver when you rinse

it. This is normal and not dangerous

because all electronics are enclosed in

a sealed power unit inside the shaver.

- Use and store the appliance at a

temperature between 5°C and 35°C.

Compliance with standards

- The appliance complies with the

internationally approved IEC safety

regulations and can be safely cleaned

under the tap (Fig. 4).

- This Philips appliance complies with all

applicable standards and regulations

regarding exposure to electromagnetic

elds.

General

- The adapter is equipped with an

automatic voltage selector and is

suitable for mains voltages ranging from

100 to 240 volts.

- The adapter transforms 100-240 volts

to a safe low voltage of less than

24 volts.

Charging

Make sure the shaver is switched off when

you start to charge it.

When you charge the shaver for the rst

time or after a long period of non-use, let it

charge continuously for 12 hours. Charging

normally takes 10 hours.

Charge the appliance when the motor

stops or starts running slower.

For optimal performance, only charge the

shaver when the battery is low.

Do not leave the appliance connected to

the mains for more than 24 hours.

1 Put the adapter in the wall socket.

, The charging light goes on to indicate

that the appliance is charging (Fig. 5).

ENGLISH

Introduction

Congratulations on your purchase and

welcome to Philips! To fully benet from

the support that Philips offers, register your

product at www.philips.com/welcome.

General description (Fig. 1)

1 Protection cap

2 Shaving heads

3 Shaving unit

4 Hair chamber

5 Handle

6 On/off slide

7 Socket for small plug

8 Wheel for retaining frame

9 Retaining frame

10 Cutter

11 Guard

12 Release button

13 Cleaning brush

14 Adapter

15 Charging light

16 Small plug

Important

Read this important information carefully

before you use the appliance and save it for

future reference.

Danger

- Keep the adapter dry (Fig. 2).

Warning

- The adapter contains a transformer.

Do not cut off the adapter to replace

it with another plug, as this causes a

hazardous situation.

- This appliance is not intended for use

by persons (including children) with

reduced physical, sensory or mental

capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning

use of the appliance by a person

responsible for their safety.

- Children should be supervised to

ensure that they do not play with the

appliance.

- Always unplug the appliance before

you clean it under the tap.

Caution

- Never immerse the appliance in

water (Fig. 3).

Note: Charge the shaver for at least 8 hours

but not more than 24 hours.

2 Remove the adapter from the wall

socket and pull the plug out of the

shaver when the battery is fully

charged (Fig. 6).

Note: The shaver does not run from the mains.

When the battery is empty, you have to

recharge the battery before you can use the

shaver again.

Cordless shaving time

A fully charged shaver has a cordless shaving

time of approximately 45 (S360), 30 (S331,

S330, S321) or 20 (S311, S301, S300)

minutes.

Using the appliance

Your rst shaves may not bring you the

result you expect and your skin may even

become slightly irritated. This is normal.

Your skin and beard need time to adapt to

any new shaving system. We advise you to

shave regularly (at least 3 times a week)

with this shaver for a period of 3 weeks to

allow your skin to adapt to the new shaver.

Shaving

Note: The shaver cannot be used directly from

the mains.

1 Remove the protection cap.

2 Push the on/off slide upwards to

switch on the shaver (Fig. 7).

3 Move the shaving heads over your

skin. Make both straight and circular

movements (Fig. 8).

Note: Do not use the shaver in combination

with gel or foam.

Note: Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

4 Push the on/off slide downwards to

switch off the shaver.

5 Clean the shaver after every shave

(see chapter ‘Cleaning and

maintenance’).

6 Put the protection cap on the

shaver to prevent damage and

dirt accumulation in the shaving

heads (Fig. 9).

Register your product and get support at

www.philips.com/welcome

4222.002.5676.1

S360, S330, S331, S321,

S311, S301, S300

1

2

3 4

5

6 7

8 9

10

11

12 13

14

15 16

17

18 19

20 21

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Philips S321 Shaver. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Philips. They might be able to provide an original manual. Are you looking for the manual of your Philips S321 Shaver in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Philips Shavers
More manuals of Shavers

Frequently Asked Questions about Philips S321 Shaver

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Philips RQ370 Shaver

Manual

Philips PT856 Shaver

Manual

Philips QP2529 One Blade Shaver

Manual

Philips PQ217 Shaver

Manual

Philips AT799 AquaTouch Shaver

Manual

Philips PQ218 Shaver

Manual

Philips QP2527 One Blade Shaver

Manual

Philips PT874 Shaver

Related categories