Manual Kichler 84324CG Keele Lamp

Manual

Fixture Diagram

Parts List

[A] Outlet Box

[B] Mounting Plate

[C] Canopy

[D] Countersunk

Mounting Screw

[E] Plate Mounting

Screw

[F] Cable Strain Relief

[G] Support Cable

[H] Swag Hook

[I] Cap

[J] Drywall Anchor

[K] Drywall Mounting

Screw

Cauons

CAUTION – RISK OF SHOCK –

Disconnect Power at the main circuit breaker panel or main fusebox before

starng and during the installaon.

WARNING:

This xture is intended for installaon in accordance with the Naonal Electrical

Code (NEC) and all local code specicaons. If you are not familiar with code

requirements, installaon by a cered electrician is recommended.

DIMMING:

This LED xture is compable with most standard incandescent dimmers, LED

dimmers, and electronic low voltage dimmers.

For opmal performance, an electronic low voltage dimmer should be used.

See kichler.com/dimming for a list of compable dimmers.

CLEANING:

• Always be certain that electric current is turned o before cleaning.

• Only a so damp cloth should be used. Harsh cleaning products may damage

the nish.

Installaon Instrucons

1) Remove mounng plate[B] from canopy[C] by unscrewing three (3)

countersunk mounng screws[D] from side of canopy. Retain screws for re-

aaching canopy to mounng plate.

2) Aach mounng plate[B] to outlet box[A] using the plate mounng

screws[E]. Mounng plate can be adjusted to suit posion of xture.

3) Adjust support cable[G] to the desired length. To shorten the cable, push

up on the cable at the cable strain relief[F] aached to the canopy and push

cable into canopy. To lengthen the cable, push up on the cable strain relief

and gently pull down on the cable to the desired length.

4) Grounding instrucons: (See Illus. a or b).

a) On xtures where mounng plate is provided with a hole and two raised

dimples, wrap ground wire from outlet box around green ground screw,

and thread into hole.

b) On xtures where a cupped washer is provided, aach ground wire from

outlet box under cupped washer and green ground screw, then thread

into mounng plate.

If xture is provided with ground wire, connect xture ground wire to outlet

box ground wire with wire connector aer following the above steps. Never

connect ground wire to black or white power supply wires.

5) Make wire connecon. Reference chart below for correct connecons and

wire accordingly.

Connect Black or Red

Supply Wire to:

Connect White Supply

Wire to:

Black White

*Parallel cord (round &

smooth)

*Parallel cord (square &

ridged)

Clear, Brown, Gold or

Black without Tracer

Clear, Brown, Gold or Black

with Tracer

Insulated wire (other

than green) with copper

conductor

Insulated wire (other

than green) with silver

conductor

*Note: When parallel wire (SPT

1 & SPT 2) are used. The neutral

wire is square shaped or ridged

and the other wire will be round

in shape or smooth (See illus.)

Neutral Wire

6) Raise xture to ceiling, carefully passing canopy[C] over mounng plate[B].

NOTE: Make sure wires do not get pinched between canopy and ceiling.

7) Align three (3) holes on side of canopy with three (3) holes on ange of

mounng plate.

8) Secure canopy to mounng plate using countersunk mounng screws[D]

previously removed from canopy.

OPTIONAL SWAGGED CABLE INSTRUCTIONS:

9) Determine desired locaon for swag hook[H]. Drill 5mm (3/16") hole in

ceiling and install drywall anchor[J] at the desired locaon.

10) Aach swag hook[H] to drywall anchor using drywall mounng screw[K].

11) Aer hook is secured to ceiling, screw on cap[I] to boom of hook.

12) Route support cable[G] through swag hook as shown.

GREEN GROUND

SCREW

CUPPED

WASHER

OUTLET BOX

GROUND

FIXTURE

GROUND

DIMPLES

WIRE CONNECTOR

OUTLET BOX

GROUND

GREEN GROUND

SCREW

FIXTURE

GROUND

a

b

For warranty informaon please visit: kichler.com/warranty

This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions:

1) This device may not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause undesired operaon.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will

not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which

can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separaon between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Informaon:

REV 14-APR-2021 IS-84324-US

We’re here to help 866-558-5706

Hrs: M-F 9am to 5pm EST

SWAGGED HOOK

INSTALLATION (OPTIONAL)

D

A

E

B

C

F

G

J

H

K

I

84324

SWAGGED HOOK INSTALLATION

(OPTIONAL):

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Kichler 84324CG Keele Lamp. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Kichler. They might be able to provide an original manual. Are you looking for the manual of your Kichler 84324CG Keele Lamp in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Kichler Lamps
More manuals of Lamps

Frequently Asked Questions about Kichler 84324CG Keele Lamp

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Kichler 16016CBR30 VLO Lamp

Manual

Kichler 15607AZT Surface Lamp

Manual

Kichler 15420AGZ Cotswold Lamp

Manual

Kichler 16019AZT27 VLO Lamp

Manual

Kichler 15820CBR30 Stepped Lamp

Manual

Kichler 15322AGZ Cross Lamp

Manual

Kichler 15608AZ In Lamp

Manual

Kichler 15439TZT Fundamentals Lamp

Related categories