Home > Home & Decoration > Lamps > Kichler Lamps > Kichler 15806BKT27R Shallow Lamp

Manual Kichler 15806BKT27R Shallow Lamp

Need a manual for your Kichler 15806BKT27R Shallow Lamp? Below you can view and download the PDF manual for free in English. This product currently has 7 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

INSTALLATION INSTRUCTIONS

Models 15805 (CP300457) & 15806 (CP300489)

SAFETY INSTRUCTIONS

READ THESE INSTRUCTIONS FIRST.

SAVE FOR FUTURE REFERENCE.

This ﬁxture is intended for installation in accordance with the

National Electric Code (NEC) and Local code speciﬁcations.

Failure to adhere to these codes and instructions may result in

serious injury and/or property damage and will void the warranty.

1) WARNING: This ﬁxture is not to be installed within 10 feet (3M)

of a pool, spa or fountain.

2) This ﬁxture is to be used only with a power unit (transformer)

rated a maximum of 300 W (25 AMPS) 15 volts.

3) The #18 ga. ﬁxture wire is not intended for direct burial.

4) Direct burial rated wire is to be buried a minimum of 6”

(152mm) beneath the surface of the ground.

NOTE: If additional Direct Burial wire is needed, contact your

local Kichler

landscape distributor.

• 8 GA wire can be purchased in length of 250’ (76 M), 15503-BK.

• 10 GA wire can be purchased in length of 250’ (76 M),

15504-BK.

• 12 GA wire can be purchased in lengths of 100’ (30 M),

15501-BK; 250’ (76 M), 15502-BK; 500’ (152M), 15505-BK; and

1000’ (304 M), 15506-BK.

5) Wiring connections must be made with approved/listed wire

connection device(s) suitable for the application. Do not exceed

manufacturers’ wiring combination speciﬁcations for size and

quantity of conductors.

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW

VOLTAGE), CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COM-

BUSTIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE

NEEDLES, GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMU-

LATED ON THE LIGHT BULB, LENS, OR BODY OF THE FIXTURE.

ASSEMBLY AND INSTALLATION

1) Determine desired location for mounting ﬁxture.

2) At desired location, hammer stake (A) into ground. To avoid

damage to stake, place a board on top of stake while hammering.

If ground is hard and stake is difﬁcult to install, make a cross

cut in ground using a ﬂat shovel.

3) Clear away area in ground at wireway slot (B) in top of stake (A).

4) Lay 12V cable into wireway slot (B) and screw stem (C) into

stake (A). If assembly does not look straight, adjust by pushing

or pulling on stake only.

5) TURN OFF POWER.

6) Make wire connection to main low voltage supply wire using

supplied twist-on wire connectors following instructions on bag.

INSTRUCCIONES PARA INSTALAR

Models 15805 (CP300457) & 15806 (CP300489)

INSTRUCCIONES DE SEGURIDAD

PRIMERO LEA ESTO

GUARDE ESTAS INSTRUCCIONES

Este artefacto se debe instalar de acuerdo con el Código

Eléctrico Nacional (NEC, por sus siglas en inglés) y con las

especiﬁcaciones del código local. No cumplir con estos códigos

e instrucciones puede resultar en lesiones graves y/ o en daños

a la propiedad y anulará la garantía.

1) Advertenciaertencia: Este artefacto no debe instalarse a menos

de 10 pies (3 m) de una piscina (alberca), spa o fuente.

2) Este artefacto debe utilizarse solamente con una unidad de

potencia (tranformador) con capacidad nominal máxima de 300

vatios (25 amp.) 15 voltios.

3) El alambre del artefacto calibre No. 18 no es para soterrado directo.

4) El alambre clasiﬁcado para soterrado directo se debe enterrar

un mínimo de 6 pulgadas (152 mm) debajo de la superﬁcie del

terreno.

NOTA: Si necesita alambre de soterrado directo adicional,

comuníquese con su distribuidor local Kichler® de productos de

jardinería ornamental.

• El alambre calibre 8 puede comprarse en longitud de 250’ (76 m.),

15503-BK

• El alambre calibre 10 puede comprarse en longitud de 250’

(76 m.), 15504-BK

• El alambre calibre 12 puede comprarse en longitudes de 75’

(22 m.), 15550-BK; 100’ (30 m.), 15501-BK; 250’ (76 m.),

15502-BK; 500’ (152 m.), 15505-BK; y 1000’ (304 m.), 15506-BK.

5) Las conexiones de cableado se deben hacer con las conexiones

Date Issued: 10/23/15 IS-15805-US

del(los) dispositivos) de conexión de cableado aprobados/ de

la lista, adecuados para la aplicación. No exceda las especiﬁcaciones

de combinación de cableado del fabricante para el tamaño y

cantidad de conductores.

PRECAUCION

CUANDO SE INSTALE SISTEMAS DE ALUMBRADO KICHLER PARA JARDINES (YA

SEA DE VOLTAJE DE LINEA O CON VOLTAJE BAJO) SE DEBE TENER CUIDADO DE

MAINTNERLOS ALEJADOS DE MATERIALES QUE PUEDAN SER COMBUSTIBLES

EN POTENCIA.

AL DAR SERVICIO DE MANTENIMIENTO A ESTOS SISTEMAS, ASEGURESE DE

DESPEJAR LAS HOJAS, CONOS DE PINO, RECORTES DEL PASTO, CUBIERTA DE

PAJA O CUALQUIER BASURA QUE SE HAYA ACUMULADO EN LA BOMBILLA DE

LUZ, EL LENTE O EL SOPORTE DE LA BOMBILLA.

MONTAJE E INSTALACIÓN

1) Determine el lugar deseado para montar el artefacto.

2) En el lugar deseado, martille la estaca (A) en el suelo. Para

evitar dañar la estaca, coloque una tabla en la parte superior

de la estaca mientras esté martillando. Si el suelo es duro y es

difícil instalar la estaca, haga un corte cruzado en el suelo

usando una pala plana.

3) Limpie el área del suelo en la ranura (B) del canal de alambres

en la parte superior de la estaca (A).

4) Coloque el cable de 12 V en la ranura (B) del canal de alambres

y atornille el vástago (C) en la estaca (A). Si el montaje no se ve

derecho, ajuste empujando o estirando de la estaca solamente.

5) APAGUE LA ALIMENTACIÓN ELÉCTRICA.

6) Haga las conexiones de cableado usando los conectores de

cable girar-en suministrados siguiendo las instrucciones de la

bolsa.

For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page

Para informacion de la garantia por favor visite: www.landscapelighting.com/portal/warranty_page

We’re here to help 866-558-5706

Hrs: M-F 9am to 5pm EST

Rating

Let us know what you think about the Kichler 15806BKT27R Shallow Lamp by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the Kichler 15806BKT27R Shallow Lamp?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the Kichler 15806BKT27R Shallow Lamp. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Kichler 15806BKT27R Shallow Lamp. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Kichler. They might be able to provide an original manual. Are you looking for the manual of your Kichler 15806BKT27R Shallow Lamp in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand	Kichler
Model	15806BKT27R Shallow
Category	Lamps
File type	PDF
File size	0.1 MB

All manuals for Kichler Lamps
More manuals of Lamps

Frequently Asked Questions about Kichler 15806BKT27R Shallow Lamp

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Is all LED lighting dimmable? Verified

No, not all LED lights are dimmable. This is indicated on the packaging or the light itself.

This was helpful (462) Read more

I put a new light in my lamp but it won't turn on, why is that? Verified

Some lamps are made for light sources of a specific wattage. When a light source is inserted that requires a higher wattage than the lamp can provide, the light may not turn on. If the lamp delivers a much higher wattage than what the light source is made for, the light source can burn out.

This was helpful (315) Read more

Why is the colour of light important? Verified

There generally are two kinds of light, warm light and cold light. Cold light keeps you sharp and awake. Warm light has a relaxing effect. The warmth of the light is measured in Kelvin and is indicated on the packaging of the lamp itself.

This was helpful (255) Read more

What is lumen? Verified

Lumen is a measuring unit for the total amount of visible light emitted by a source.

This was helpful (190) Read more

What screw bases exist? Verified

Worldwide there many types of sockets, but most used are those based on the Edison screw, indicated with the letter E. In most countries screw bases E27 and E14 are standard. In the United States E26, E17, E12 and E10 are standard.

This was helpful (142) Read more

What do watts say about my lamp? Verified

Watt is a measuring unit for electricity consumption. Lamps that produce more light, generally use more Watt, but for comparing light output you should always use lumen.

This was helpful (113) Read more