Manual Winix XQ Air Purifier

Need a manual for your Winix XQ Air Purifier? Below you can view and download the PDF manual for free in English. This product currently has 1 frequently asked question, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

Loading…

1
4
2
5
3
6
WHERE TO USE
MODEL PART DIAGRAM
12~18 in 12~18 in
Allow 12 ~ 18 in. of space between TVs, radios, and other electronics
Electromagnetic interference from certain electronics may cause
product malfunction.
Place indoors away from direct sunlight
Direct exposure may cause product malfunction or failure.
Only place on hard, flat surfaces
Flimsy or slanted surfaces may result in abnormal noise and vibrations.
Allow at least 12 ~ 18 in. from walls for maximum air flow
DISPLAY
01
06
07 08
02 03 04 05
01. Child Lock Indicator
LED light indicates whether Child Lock mode is enabled or disabled.
02. Timer Indicator
If the timer has been set, the LED light indicates the set time of operation.
03. Wi-Fi Indicator
Indicates whether Wi-Fi Mode is enabled or disabled.
04. Sleep Mode Indicator
Indicates whether Sleep Mode is enabled or disabled.
05. Filter Replacement Indicator
LED light indicates when it is time to change the filter.
06. Ultrafine Dust Density Indicator
The LED Ultrafine Dust Density Indicator displays the quality of air in your environment. When the unit senses an air
quality change, it automatically adjusts the LED Indicator to display the respective air quality.
LED Numeric Particle Sensor displays air quality measures fine particles down to 2.5 microns.
07. Mode Indicator
Indicates whether Auto & Fan Speed Mode is enabled or disabled.
08. PlasmaWave 2.0 Indicator
Indicates whether PlasmaWave 2.0 is enabled or disabled.
CONTROL PANEL
01. Wi-Fi / Pairing Button
A quick press will turn Wi-Fi on/off.
A long press of 3 seconds will activate pairing mode.
A Wi-Fi indicator will display on the front while Wi-Fi is active.
02. Filter Life / Filter Reset Button
A quick press will show the remaining filter life;
indicated on the front display (100 ~ 0%).
A long press of 10 seconds will reset the filter life indicator.
- Use when replacing the filters.
- Filter Reset Button can be used when the power is turned off.
- The filter life will be reset to 100%.
03. Sleep Mode / Child Lock Button
A quick press of the Sleep Mode / Child Lock Button cycles
the unit in order from Sleep Mode
General Mode
Sleep Mode.
In Sleep Mode, the Sleep Mode LED icon on the front indicator
dims to 50% brightness. All other LEDs are turned off.
If you press Sleep Mode / Child Lock Button for 3 seconds,
Child Lock will be initiated and the buttons will not operate.
A chime will sound if pressed.
04. PlasmaWave 2.0 Operation Button
Turns the PlasmaWave 2.0 feature on/off.
When the unit is running, you may hear a chirping or buzzing
sound.
The sound is from large particles passing through PlasmaWave
2.0, it is normal and does not signify product failure.
05. Timer Button
A quick press of the Timer Button will set the timer.
The timer can be set in hours,
in the order of 0(default)
1
2
4
8
12
0.
The amount of time, in hours, is indicated on the front numeric
display.
Timer Indicator displays when timer is in use.
06. Fan Speed Button
Enables manual operation of the unit's fan speeds.
Press to cycle through and set the desired fan speed (Auto, Low,
Medium, High, Turbo).
Auto Mode:
- Auto Mode automatically adjusts fan speeds according to your
indoor air quality. The fan speed will adjust to low when air
quality is good, medium when fair, and to high when poor.
07. Power Button
Turns the unit on or off.
During the first 30 seconds of powering up, the Air Quality
Indicator will cycle through Blue, Amber and Red colors. Odor
Sensor takes approximately 4 minutes to detect the air quality in
the environment before normal operation begins.
When to Replace Filters
Filter Indicator Light When to Service When to Replace
Pre-Filter
none Clean once every 14 days Permanent
CD Carbon Filter
Can NOT be WASHED
Replace every 12 months
True HEPA Filter
Lasts up to 12 months
When the Check Filter Indicator LED is on, it is time to replace the True HEPA Filter and CD Carbon Filter.
Intervals between filter replacement may vary depending on environment.
MAINTENANCE
03
True HEPA Filter
04
PlasmaWave 2.0
02
CD Carbon FilterPre-Filter
01
4-STAGE AIR PURIFICATION
01. Pre-Filter
Designed to catch larger airborne particles found
indoors.
02. Coated Deodorization (CD) Carbon Filter
Reduces VOCs and household odors from cooking,
pets, and smoke.
03. True HEPA Filter
Captures 99.97%* of airborne allergens including;
pollen, mold spores, dust, pet dander, microbes, and
smoke. (*Particles as small as 0.3 microns in size.)
04. PlasmaWave 2.0
Creates Hydroxyls which can help to reduce the
presence of airborne Bacteria and Viruses.*
(*Based on independent laboratory test conducted
on Influenza A Virus (H1N1), Cat Calicivirus (Feline
Calicivirus), Dog Coronavirus (Canine Coronavirus),
Highly Pathogenic Avian Influenza (H5N1_Influenza
A subtype), Avian Influenza (H7N9_Avian Influenza),
Human Coronavirus 229E, Zika Virus, E. coli,
Pseudomonas aeruginosa, Staphylococcus aureus,
VOC.)
INITIAL OPERATION
Latch
1.
Remove the front/rear panel by grasping its upper
edge and gently pulling forward.
- To remove the front/rear panel, release the latch
at the lower edge of the panel.
2.
Remove the Pre-Filter, then the plastic bag of
filters behind it.
3.
Remove filters from protective plastic bag.
02
01
03
4.
Install the filters until they fit securely in place.
03. True HEPA Filter (back)
02. CD Carbon Filter (middle)
01. Pre-Filter (front)
Latch
5.
After filters are installed, close the front panel.
6.
Insert the power cord into an electrical outlet.
REPLACING FILTERS
CLEANING CARE
Cleaning the Filters:
Use a vacuum cleaner or soft brush to clean the Pre-Filter
If it is excessively soiled, rinse in room temperature water.
Do not use detergent or soap.
Allow the filter to dry for 24 hours or more before
using.
Intervals between filter cleaning may vary depending
on the air quality in the environment
.
Cotton
swab
Lens
01 02 03 04 05 06 07
CONTROLS
After replacing the filters, turn the power
on and press and hold the Filter Reset
Button tor 10 seconds.
1. Grasp the back of the grill and lift up.
2. Wipe the interior and grill with a soft, damp
cloth.
3. To reinstall the grill, insert the two front
tabs of the grill into the corresponding
holes in the product.
* For optimal performance, clean every 1 - 2 months.
NOTICE
When cleaning the unit, always unplug the power cord first and
then wait until the unit has cooled down.
Never disassemble, repair, or modify this unit yourself.
Do not use flammable sprays or liquid detergents.
Do not allow children to clean or maintain the unit.
Before cleaning or maintaining, ensure unit is unplugged.
1.
Open the front panel and clean the interior with a vacuum
cleaner.
A handheld vacuum or hose attachment will work best.
2.
Dampen a cloth with room temperature water and wipe
down the interior and exterior of the unit.
3.
Wipe the unit down with a clean, dry cloth.
Ensure no moisture remains before plugging the unit back in.
1.
Use a damp cotton swab to wipe
the lens and intake area of the
Dust Sensor.
To clean the sensor area, use
only water. Do not use volatile
substances such as alcohol or
acetone.
2.
Wipe away any remaining moisture with a dry
cotton swab.
Grill
Button Control Section
Display
CD Carbon Filter
Rear Panel
Side Vent
Pre-Filter
Front Panel
True HEPA Filter
Air Quality Indicator
(2) Pre-Filter
(2) CD Carbon Filters
(2) True HEPA Filters
Unit
User
Manual
Tower XQ
Wi-Fi Setup Guide
Cleaning the Dust Sensor:
Cleaning the Top:
Cleaning the Exterior & Interior:
NOTICE
Do not use benzene, alcohol, or other volatile fluids, which
may cause damage or discoloration.
Do not use hot water over 104
.
Download manual in English (PDF, 2.75 MB)
(Consider the environment and only print this manual if it is really necessary)

Loading…

Rating

Let us know what you think about the Winix XQ Air Purifier by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.
Are you satisfied with the Winix XQ Air Purifier?
Yes No
Be the first to rate this product
0 votes

Join the conversation about this product

Here you can share what you think about the Winix XQ Air Purifier. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Winix XQ Air Purifier. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Winix. They might be able to provide an original manual. Are you looking for the manual of your Winix XQ Air Purifier in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand Winix
Model XQ
Category Air Purifiers
File type PDF
File size 2.75 MB

All manuals for Winix Air Purifiers
More manuals of Air Purifiers

Frequently Asked Questions about Winix XQ Air Purifier

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Does an air purifier also remove regular dust from the air? Verified

Yes, air purifiers also remove dust from the air that otherwise would need to be removed by dusting and cleaning. It depends on the air purifier up to what size of dust can be removed from the air.

This was helpful (172) Read more
Manual Winix XQ Air Purifier

Related products

Related categories