Manual Whirlpool AKT 6410/NB Hob

Manual

of problems, contact the dealer or your nearest After-

sales Service. Once installed, packaging waste (plastic,

Styrofoam parts etc.) must be stored out of reach of

children - risk of suocation. The appliance must be

disconnected from the power supply before any

installation operation - risk of electrical shock. During

installation, make sure the appliance does not damage

the power cable - risk of re or electrical shock. Only

activate the appliance when the installation has been

completed.

The electrical and gas connections must comply

with local regulation.

WARNING : Modication of the appliance and its

method of installation are essential in order to use

the appliance safely and correctly in all the additional

countries.

Use pressure regulators suitable for the gas

pressure indicated in the instruction.

The room must be equipped with an air extraction

system that expels any combustion fumes.

The room must also allow proper air circulation,

as air is needed for combustion to occur normally.

The ow of air must not be less than 2 m3/h per kW

of installed power.

The air circulation system may take air directly

from the outside by means of a pipe with an inner

cross section of at least 100 cm2; the opening must

not be vulnerable to any type of blockages.

The system can also provide the air needed for

combustion indirectly, i.e. from adjacent rooms tted

with air circulation tubes as described above. However,

these rooms must not be communal rooms, bedrooms

or rooms that may present a re hazard.

Liquid petroleum gas sinks to the oor as it is

heavier than air. Therefore, rooms containing LPG

cylinders must also be equipped with vents to

allow gas to escape in the event of a leak. As a result

LPG cylinders, whether partially or completely full,

must not be installed or stored in rooms or storage

areas that are below ground level (cellars, etc.). It is

advisable to keep only the cylinder being used in

the room, positioned so that it is not subject to

heat produced by external sources (ovens,

replaces, stoves, etc. ) which could raise the

temperature of the cylinder above 50°C.

Carry out all cabinet cutting works before tting

the appliance in the furniture and remove all wood

chips and sawdust.

If the appliance is Not installed above an oven, a

separator panel (not included) must be installed in

the compartment under the appliance.

Should you experience diculty in turning the burners knobs, please

contact After Sales Service for replacement of the burner tap if found to

be faulty.

The openings used for the ventilation and dispersion of heat must never

be covered.

GAS CONNECTION

WARNING : Prior to installation, ensure that the

local distribution conditions (nature of gas and gas

pressure) and the adjustment of the appliance are

compatible.

Check that the pressure of the gas supply is

consistent with the values indicated in Table 1

(“Burner and nozzle specications”).

WARNING : The adjustment conditions for this

appliance are stated on the label (or data plate).

WARNING : This appliance is not connected to a

combustion products evacuation device. It shall be

installed and connected in accordance with current

installation regulations. Particular attention shall be

given to the relevant requirements regarding

ventilation.

If the appliances is connected to liquid gas, the

regulation screw must be fastened as tightly as

possible.

IMPORTANT : When gas cylinder is adopted, the

gas cylinder or gas container must be properly

settled (vertical orientation).

WARNING : This operation must be performed by

a qualied technician

Use only exible or rigid metal hose for gas connection.

Connection with a rigid pipe (copper or steel)

Connection to the gas system must be carried out in

such a way as not to place any strain of any kind on

the appliance. There is an adjustable L-shaped pipe

tting on the appliance supply ramp and this is

tted with a seal in order to prevent leaks. The seal

must always be replaced after rotating the pipe

tting (the seal is provided with the appliance). The

gas supply pipe tting is a threaded 1/2 gas

cylindrical male attachment.

Connecting a exible joint less stainless steel

pipe to a threaded attachment The gas supply pipe

tting is a threaded 1/2 gas cylindrical male

attachment. These pipes must be installed so that

they are never longer than 2000 mm when fully

extended. Once connection has been carried out,

make sure that the exible metal pipe does not

touch any moving parts and is not compressed.

Only use pipes and seals that comply with current

National regulations.

IMPORTANT : If a stainless steel hose is used, it

must be installed so as not touch any mobile part of

the furniture (e.g. drawer). It must pass through an

area where there are no obstructions and where it is

possible to inspect it on all its length.

The appliance should be connected to the main

gas supply or to gas cylinder in compliance with the

current National regulations. Before carry out the

connection, make sure that the appliance is

compatible with the gas supply you wish to use. If

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Whirlpool AKT 6410/NB Hob. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Whirlpool. They might be able to provide an original manual. Are you looking for the manual of your Whirlpool AKT 6410/NB Hob in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Whirlpool Hobs
More manuals of Hobs

Frequently Asked Questions about Whirlpool AKT 6410/NB Hob

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Whirlpool TGML 660 NB Hob

Manual

Whirlpool WL S7260 NE Hob

Manual

Whirlpool WL S3777 NE Hob

Manual

Whirlpool SMP2 9010 C/NE/IXL Hob

Manual

Whirlpool ACT7324/BLV Hob

Manual

Whirlpool GOWL 758/WH Hob

Manual

Whirlpool GOA 6425/NB1 Hob

Manual

Whirlpool SMP 9010 C/NE/IXL Hob

Related categories