Uncommon USA, Inc.
10. Secure the 24 light strands to the metal base outer ring as
shown in Fig. 7.
Fig. 7
11. Raise the pole to 20 feet as shown in Fig. 8, tighten the center ring
support. Connect the power transformer to a power outlet. The power
transformer should be off the ground to avoid being covered by snow,
ice or water.
Power Transformer:
Input: 120VAC 60Hz
Output: 24VAC 1000mA
12. Set flashing modes. As shown in Fig. 9, there are 8 modes to choose from,
including steady lights or various flashing selections. #8 is a rotation of#l
through #7. Point the remote controller to the sensor (as shown in Fig. 9a)
atop the tree light kit and press the number to select your desired mode
and enjoy the lights. Note: This tree light kit uses an infrared remote
system. The remote unit must be pointed to the sensor without being
blocked by a wall, glass or other obstacles. It has a limited distance
of 30
ft.
between the remote unit and the sensor.
Fig. 8
Point this end
/ to the sensor
Press to power on/off
the lights
Remote
Note:
Do not operate this infra-
red remote under sunlight.
Sunlight interferes with
infrared.
Setup Instructions
Note: Follow the instructions on the
back of the remote unit for battery
replacement. Battery type: CR2025
CR2032
Note: Be sure the sensors face out as shown in Fig. 9a
to receive the remote control signal. Adjust the sensor
unit if needed.
pelNT REMOTE TO
SENSOR TO OPERATE
($EMS(il\lOCAn;OATOI'
'lIlE
rneturutt
J(lT)
Fig. 9 ATTENTION
QPeRtitlOML AAW3E:
/.IAX.lO'H,fltW~~liWl£lOSf1iSQl!
Remove the battery
tab to activate the
""UGIIT,"
".<u,
remote controller
~:-a.1II!1
Attention:
Remote controller
1. To prevent strands from getting tangled, each time you need to lower the pole to do any adjustments,
you must strap the light strands 2 times with 6 strands in a group (four groups for a tree set) using the
Velcro strips. Please refer to the details in "Take-down Instructions."
2. If you have a 25 ft. pole, you will not pull out the top section ofthe pole to set up this light set.
3. It is normal that the power transformer turns warm when it is working.
4. Raise the light kit high enough above the ground. Do not let water, snow, or ice cover the light kit base.
This will ensure the lights work properly, and will help the metal base be kept in good conditions.
Important
Do not let power transformer submerge or soak in water. Use only the power transformer included with this
product. Do not use any other transformers. Improper use of transformer may damage both the product and •
the transformer, and may cause the risk of fire. Connect the power cord to the transformer, and then connect
the transformer to a power outlet.
ProductVVarranty
Uncommon USA, Inc. offers a limited 90 day warranty against manufacturer defecus) from the date of purchase
when this product is employed as stated in this instruction manual.
Model No. MLT-15 / WLT-15
Made in China
Page 3
Join the conversation about this product
Here you can share what you think about the Uncommon USA WLT-15 Christmas Tree. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.