1110
Operational Precautions
For prevention of damage
Wipe plastic areas such as the main unit and re-
mote control with a soft cloth tightly wrung out with
water.
Dry cloth or tissue
Do not lean against the toilet lid.
For prevention of malfunctions and
failures
Do not block the remote control transmitter or receiver.
May cause main unit to malfunction.
Turn the power OFF if there is a risk for lightning
strike.
*1
A toilet seat cover or a toilet lid cover cannot be used.
Otherwise, the body sensor
*2
and seat sensor may not
detect properly.
Additionally, the toilet seat and lid may not open or close
properly.
Covers
Do not urinate on the main unit, toilet seat or wand.
Doing so may cause a failure or discoloration.
Do not apply strong forces to the control panel of
the remote control.
When using a toilet cleaner to clean the toilet, rinse
it off within 3 minutes and leave the toilet seat and
toilet lid open.
If vapor from a toilet cleaner enters the main unit, it may
cause a malfunction.
Wipe off any cleaner that remains on the bowl unit.
Note: If "Auto fl ush lid closed
*3
" (
Pages 32, 33) is turned
ON and you use the remote control to fl ush the bowl unit, the
toilet seat and lid close before fl ushing the bowl unit.
After the bowl unit has been fl ushed, open the toilet seat and lid.
Do not use the product with the toilet lid removed.
Do not expose to direct sunlight.
Doing so may cause changes in color, irregular heated
seat temperature or remote control malfunction.
It may also cause product malfunction due to the
change in temperature.
Use radios, etc. away from the product.
The product could cause interference with the radio
signal.
If you use a booster seat for infants or a soft high-
chair, remove it after use.
Keeping it installed may prevent some of the functions
from being used.
Do not apply force to the remote control.
This cause malfunction.
To prevent the remote control from being dropped,
set it in the hanger when you are not using it.
Be careful not to expose it to water.
Do not place anything on the toilet seat, and do not
press them with hands.
Doing so may activate the seat sensor, causing the
fl oor to get wet if buttons on the remote control are
touched and warm water comes out from the wand.
■
Body Sensor Compliance
●FEDERAL COMMUNICATIONS COMMISSION
(FCC) INTERFERENCE STATEMENT
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
CAUTION:
Any changes or modi
cations not expressly approved by
the grantee of this device could void the user’s authority to
operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RF exposure warning
This equipment complies with FCC RF exposure limits set
forth for an uncontrolled environment.
This equipment must not be co-located or operating in
conjunction with any other antenna or transmitter.
●Canada, Industry Canada (IC) Notices
This device complies with Industry Canada’s licence-
exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below
the Industry Canada (IC) radio frequency exposure limits.
The Wireless Device should be used in such a manner
such that the potential for human contact during normal
operation is minimized.
This device has also been evaluated and shown compliant
with the IC RF Exposure limits under portable exposure
conditions.
(antennas are less than 8 inch (20 cm) of a person's
body).
*1 How to turn off the product (
Page 17)
*2 Except SW4736AT40, SW4736, SW4734AT40, SW4734
*3 Except SW4726AT40, SW4726, SW4724AT40, SW4724
Introduction Introduction
Join the conversation about this product
Here you can share what you think about the TOTO SW472612 Toilet Seat. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.