Home > Computers & Software > Headsets > SoundBot Headsets > SoundBot SB270 Headset

Manual SoundBot SB270 Headset

Need a manual for your SoundBot SB270 Headset? Below you can view and download the PDF manual for free in English. This product currently has 6 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

3Charge headset for at least 3 hours.

(via MicroUSB)

- Red LED will light up when charging.

- Red LED will be o once fully charged.

- Be sure headset is powered o before

going to next step.

Pairing your SB270 via Bluetooth.

- Press and hold the multifunction key for 7

seconds until blue and red lights ash.

- Enable the Bluetooth function on the mobile

phone or computer or other pairing device.

- Search for Bluetooth devices from your

pairing device (phone, tablet or PC).

- Select “SB270” and connect. A beep will

conrm successful pairing.

Power on: 3 rapid blinks of blue light

Power o: 3 rapid blinks of red light blinks

Standby: blue light blinks once every 5 seconds

Incoming call: quick continuous blinks of blue light

In use: blue light blinks once every 5 seconds

Charging mode: red light stays on or blinks

Fully charged: red light will be turned o

Low battery alarm: red light blinks once every 30 seconds

LED Indicators

SENSORY TOUCH CONTROL

Voice Dialing

- Double click the multifunction button

(Note: Your phone must support this function)

Touch Controls (one notch per swipe)

- Pause/Play music: Touch the middle of headphone

and press lightly to play or pause the music.

- Increase/decrease volume: Use one nger to slide

from the top to the bottom to decrease the volume

and vice versa to increase volume.

volume+/next track

volume-/previous track

microphone

3.5mm audio port

LED

micro usb port

multifunction button

Basic Operation

Powering on: Press and hold multifunction button for 3 seconds. Blue light

blinks 3 times and headphone beeps to indicate that power is on.

Answering a call: Short press multifunction button to take the call.

Ending a call: Short press multifunction button until headphone beeps.

Rejecting a call: Press and hold the multifunction button for two seconds

until headphone beeps.

Switching conversation from headphone to mobile phone: Press

multifunction button for 2 seconds, voice will be switched from headphone

to mobile phone and vice versa.

Redialing last dialed number: In stanby mode, press volume(+) button for 3

seconds until the beeping notification takes place.

Microphone mute: Press and hold volume(-) button for 2 seconds until the

headphone beeps. Press and hold volume(-) button for 2 seconds to

unmute.

Volume adjustment: short press volume(+) button to increase volume,

short press volume(-) button to decrease volume.

Play/Pause: Short press multifunction button can to play/pause music.

Forward/backward: Long press volume(-) button to play the last song, long

press volume(+) button to play next song.

Pairing mode: Deactivates automatically within 3 minutes when no device

is connected.

Auto power-off: SB270 will shut off automatically after 10 minutes of idle

activity.

Manual power-off: Press multifunction button for 6 seconds until red light

blinks 3 times and headphone beeps.

- Backward/forward: Use two ngers (the ngers

need to be spread out) to slide from the top to the

bottom to play the next song and vice versa for

previous track.

Features

Music play time: 14 hours

Talk time: 12 hours

Range: up 10 meters or 33 feet

Bluetooth standard: Bluetooth 3.0 +

EDR version with AVRCP and A2DP

Speaker: 40mm driver speaker x 2

Minimum voltage: 5V 200mAh

S undBot®

SB270

Quick Start Guide

User Manual

www.soundbot.com

experience audio excellence.

live the state of art technology.

feel the difference.

General Use and Notices

Please read the following information before using this product.

Users are not permitted to make changes or modify the product and the accessories in any way.

1. DO NOT use the product while operating a motor vehicle.

2. To avoid electronic interference and/or compatible conflicts, TURN OFF the product in any

facilities where posted notices instruct you to do so. For example: Aircraft, Military Base, Hospital

or Health Care Facilities.

3. To avoid impairing your hearing in the long-term operation, keep the headset volume in the

moderate level.

4. Keep away of fire, water, and high voltage equipment.

5. Follow the charging procedure described in this guide to charge the product.

Charging the Battery

SB270 uses a rechargeable battery. A normal charging process takes about 3 hours. The red LED

will turn on when charging and will turn off when charging is finished.

When the battery is nearly used up, the red LED will flash every 30 seconds and there will also be

a prompt from the headset. Please charge the headset at this time.

Please make sure the battery has been fully charged your first three uses to ensure the battery’s

best performance.

Always use proper AC Power Adapter (not included) to charge the headset. Using any incorrect

power supply device will cause damage and void the warranty.

Upon completion of charging, please pull out the cable from the headset t. Do not put the headset

in charging state past it being fully charged. This will shorten the lifetime of the battery.

Do not use the headset in extreme hot or cold environment. It is recommended to keep the

environment temperature between 15 and 25 degrees Celsius.

Do not install, place or use the headset near any source of heat such as a stove, radiator, oven,

toaster, coffee maker or other apparatus (including microwave oven) that gives off heat.

SoundBot® is a registered trademark of SoundBot.

Warranty and product info: http://www.soundbot.com

All trade names are registered trademarks of respective manufacturers listed.

Bluetooth technology and trademark are registered property of Bluetooth SIG.

Rating

Let us know what you think about the SoundBot SB270 Headset by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the SoundBot SB270 Headset?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the SoundBot SB270 Headset. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your SoundBot SB270 Headset. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact SoundBot. They might be able to provide an original manual. Are you looking for the manual of your SoundBot SB270 Headset in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand	SoundBot
Model	SB270
Category	Headsets
File type	PDF
File size	10.53 MB

All manuals for SoundBot Headsets
More manuals of Headsets

Frequently Asked Questions about SoundBot SB270 Headset

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Does bluetooth work through walls and ceilings? Verified

A bluetooth signal will work through walls and ceiling, unless these are made from metal. Depending on the thickness and the material of the wall the signal can lose in strength.

This was helpful (106) Read more

When I connect a headset to my device it doesn't work properly, what can I do? Verified

It is possible that dirt has amassed in the opening where the headset is connected, preventing it from making proper contact. The best way to clean this is with compressed air. When in doubt, have this done by a professional.

This was helpful (3) Read more

When is my music too loud? Verified

Sounds over 80 decibel (dB) can start to damage hearing. Sounds over 120 dB immediately damage hearing. The severity of the damage depens on how often and how long the sound is present.

This was helpful (0) Read more

What is Noise Cancelling? Verified

Noise Canceling is a technique that is mainly used in headphones. Active noise control is used to lower or eliminate the influence of ambient noise.

This was helpful (0) Read more

Up to what noise level is it safe for children? Verified

Children get their hearing damaged quicker than adults. Therefore it is important to never expose children to noise louder than 85dB. In the case of headphones there are special models for children. In case of speakers or other situations you have to be watchful the noise does not exceed that level.

This was helpful (0) Read more