■ GB / IE/NI
- 1 - - 2 - - 3 - - 4 - - 5 -
Introduction
Congratulations on the purchase of your new device.
You have selected a high-quality product. The opera-
ting instructions are a constituent of this product. They
contain important information about safety, use and
disposal. Before using the product, familiarise yourself
with all operating and safety instructions. Use this
product only as described and only for the specified
areas of application. Retain these instructions for
future reference. Please also pass these operating
instructions on to any future owner(s).
Intended use
The car cradle is an information electronics device
that is used for holding mobile phones (and other
5 V devices with a USB connection*) in the car and
charging them at the same time. The car USB adapter
is only intended for vehicles with a cigarette lighter
whose negative pole is connected to ground.
Any other use is considered to be improper, and can
result in damage and injuries. Claims of any kind for
damage resulting from improper use or unauthorised
modifications will not be considered. This product is
for private use only, and is not intended for commer-
cial use.
* USB is a registered trademark of USB Implementers
Forum, Inc..
Warnings used
DANGER
A warning notice at this hazard level indicates
an imminently hazardous situation.
Failure to avoid this hazardous situation could result
in severe injuries or even death.
► Follow the instructions in this warning notice to
avoid the risk of serious injuries or death.
CAUTION
A warning of this risk level indicates potential
damage to property.
Failure to avoid this situation could result in damage
to property.
► Follow the instructions in this warning to prevent
damage to property.
NOTE
► A note indicates additional information that will
assist you in handling the device.
Safety instructions
■ This device is not intended for use by people
(including children) with reduced physical, sensory or
mental abilities or for those without experience and/
or knowledge, unless they are being supervised by
a person responsible for their safety or have been
instructed by them in how to use the device.
■ Children should be supervised to ensure that they do
not play with the device.
DANGER
► Packaging materials such as plastic film or
polystyrene must not be used as playthings.
Risk of suffocation!
■ Check the device for any visible external damage
before use. Do not use a device that has been dama-
ged or dropped.
■ To avoid possible risks, arrange for damaged cables
or connectors to be replaced by an authorised speci-
alist or the Customer Service Department.
■ Never open the device, and never carry out
repairs yourself.
■ Protect the device from penetration by moisture
and liquids.
■ Never subject the device to extreme heat or humi-
dity. This particularly applies to storage in a car.
If the car is at a standstill for longer periods and
the weather is warm with solar irradiation, high
temperatures occur in the car interior and the
glove compartment. Remove electrical and electro-
nic devices from the vehicle.
■ When fitting the cradle, ensure that it does not get
in the way of steering, braking or the deployment
of other vehicle systems (such as airbags) and
does not restrict your field of view when driving.
■
DANGER Do not place the car cradle in the
airbag unfolding area or the vicinity thereof, since
the cradle would be flung through the vehicle
interior in the event of airbag deployment, which
could cause serious injuries.
■ Ensure that the cradle is not installed in a location
in which you could come into contact with it in the
event of an accident or collision.
■ Please also pay attention to your mobile phone/
equipment operating manual.
■ If you notice a burning smell or smoke coming
from your device, disconnect it from the cigarette
lighter immediately.
■
DANGER Under no circumstances must the
smoke be inhaled, since this could be harmful to
your health.
■ Check regularly to ensure that the suction cup at
the bottom end of the cradle is securely attached
to the windscreen. This is especially important in
areas where extreme outside temperature fluctua-
tions occur.
■ All of the applicable laws in your location must
be observed. Your hands must ALWAYS be free to
operate the vehicle safely when you are driving.
Traffic safety must ALWAYS take priority whilst
driving. Only use this cradle if no hazard can
occur in any driving situation whatsoever.
Controls
Car cradle for mobile phone
Swan neck
Suction cup locking lever
Suction cup
Car USB adapter
Signal lamp
USB connection
USB cable to mini USB
USB cable to micro USB
USB cable to Samsung Slim
** The brand Samsung is a registered trademark of
Samsung Electronics Co., Ltd., Suwon Kyonggi, KR.
Technical details
Model SKSH 2 B1
Input voltage /current 12 / 24 V
, max. 1,4 A
Output voltage/ current 5 V
, max. 2100 mA*
Fuse F2AL/250V
Distance between jaws
of cradle
approx. 5.5 - 8.6 cm
Dimensions (cradle) approx. 30 x 10.5 x 7.6 cm
Weight (cradle) approx. 160 g
Dimensions (car USB
adapter)
approx. 8.5 x 3.3 cm
Weight (car USB
adapter)
approx. 35 g
Operating temperature 15°C up to 40°C
Storage temperature 0°C up to 55°C
Relative humidity
≤ 75 %
(no condensation)
* When both USB connections are being used
simultaneously, the total power consumption of the
connected devices may not exceed 2100 mA.
Notes on the Declaration of
Conformity
This device complies with the basic
requirements and other relevant provisions
of the EMC Directive 2014/30/EU, UN
Directive R10 and RoHS Directive 2011/65/EU.
The full original Declaration of Conformity is available
from the importer.
Check scope of delivery
Before starting to use the device, check that all items
are present and undamaged. If the contents are not
complete or are damaged as a result of defective
packaging or transportation, contact the Service
Hotline (see section "Service").
Remove all parts from the packaging, and then
remove all packaging material from the device.
▯ Car cradle with suction cup
▯ Car USB adapter
▯ USB cable to mini USB
▯ USB cable to micro USB
▯ USB cable to Samsung Slim
▯ This operating manual
Handling and operation
Fitting the suction cup
Ensure that the surface to which you wish to attach
the suction cup is clean, free of grease and dry.
Ensure that the suction cup locking lever has been
released.
♦ Place the suction cup firmly against the wind-
screen and press the suction cup locking lever
downwards. This creates suction, and the suction
cup is pulled tightly against the windscreen.
♦ You can use the swan neck and the 360° rotat-
ing ball joint to adapt the cradle to your require-
ments in both a horizontal and vertical direction.
♦ To remove the suction cup from the windscreen,
pull the suction cup locking lever upwards and
pull the small tab on the edge of the suction cup
upwards.
Inserting your mobile phone in the car
cradle
♦ Press the mobile phone against the left-hand jaw of
the cradle and then pull out the right-hand jaw until
the mobile phone can be inserted into the cradle
. Then release the right-hand jaw of the cradle.
♦ To remove the mobile phone from the cradle ,
pull the right-hand jaw out a little.
Charging the mobile phone
♦ Connect the vehicle USB adapter to your vehi-
cle on-board power supply (cigarette lighter). The
signal lamp indicates that the device is ready
for operation.
♦ Connect the required USB cable to
one of the USB connections on the car USB
adapter and the mobile phone. The charging
function starts automatically.
CAUTION
► In vehicles in which the cigarette lighter also
works with the ignition switched off, the device
must be disconnected from the cigarette lighter
after use. Otherwise, the vehicle battery may be
discharged over a long period of time, since the
device also uses power when it is idle.
Changing the fuse
There is a fuse in the vehicle USB adapter for
protecting the vehicle's on-board power supply. If the
device no longer works, check the fuse and replace if
necessary.
♦ Open the vehicle USB adapter by carefully
unscrewing the screw insert anticlockwise (using
pliers if necessary) and removing it.
♦ Remove the plug tip from the fuse and take out
the fuse.
♦ Now insert a new fuse of type F2AL/250V into
the vehicle USB adapter , fit the plug tip to the
slightly protruding end of the fuse and screw the
previously removed screw insert back in.
NOTE
► If the device still does not work or the fuse blows
again immediately, the device is defective.
In this case, please contact the Service Hotline
(see chapter "Service").
Cleaning and care
CAUTION
► Always disconnect the device from the cigarette
lighter when cleaning and when it is not being
used.
■ When necessary clean the device with a soft
cloth. Check the condition of the device at regular
intervals. Do not continue to use the device if you
notice any damage
Storage while not in use
CAUTION
► The temperatures inside a vehicle can reach ext-
reme values in summer and winter. Prevent heat
damage: do not leave the device in the vehicle.
■ Store the device in a location that is clean, dry,
dust-free and sheltered from direct sunlight.
Disposal
The adjacent symbol of a crossed-out wheelie
bin means that this device is subject to Directive
2012/19/EU. This directive states that this
device may not be disposed of in normal household
waste at the end of its usable life, but must be handed
over to specially set-up collection locations, recycling
depots or disposal companies.
This disposal is free of charge for the user.
Protect the environment and dispose of this
device properly. You can obtain further informa-
tion from your local disposal company or the city or
municipal administration.
You should return all packaging materials for
environmentally-friendly disposal.
Kompernass Handels GmbH warranty
Dear Customer,
This appliance has a 3-year warranty valid from the
date of purchase. If this product has any faults, you, the
buyer, have certain statutory rights. Your statutory rights
are not restricted in any way by the warranty described
below.
The validity period of the warranty starts from the date
of purchase. Please keep your original receipt in a
safe place. This document will be required as proof of
purchase.
If any material or production fault occurs within three
years of the date of purchase of the product, we will
either repair or replace the product for you at our
discretion. This warranty service is dependent on you
presenting the defective appliance and the proof of
purchase (receipt) and a short written description of the
fault and its time of occurrence.
If the defect is covered by the warranty, your product
will either be repaired or replaced by us. The repair or
replacement of a product does not signify the begin-
ning of a new warranty period.
The warranty period is not prolonged by repairs effect-
ed under the warranty. This also applies to replaced
and repaired components. Any damage and defects
present at the time of purchase must be reported imme-
diately after unpacking. Repairs carried out after expiry
of the warranty period shall be subject to a fee.
This appliance has been manufactured in accordance
with strict quality guidelines and inspected meticulously
prior to delivery.
The warranty covers material faults or production faults.
The warranty does not extend to product parts subject
to normal wear and tear or fragile parts such as switch-
es, batteries, baking moulds or parts made of glass.
The warranty does not apply if the product has been
damaged, improperly used or improperly maintained.
The directions in the operating instructions for the
product regarding proper use of the product are to
be strictly followed. Uses and actions that are discour-
aged in the operating instructions or which are warned
against must be avoided.
This product is intended solely for private use and
not for commercial purposes. The warranty shall be
deemed void in cases of misuse or improper handling,
use of force and modifications / repairs which have
not been carried out by one of our authorised Service
centres.
Service
Service Great Britain
Tel.: 0871 5000 720 (£ 0.10/Min.)
Service Ireland
Tel.: 1890 930 034
(0,08 EUR/Min., (peak))
(0,06 EUR/Min., (off peak))
IAN 284993
Importer
Please note that the following address is not the ser-
vice address. Please use the service address provided
in the operating instructions.
KOMPERNASS HANDELS GMBH
BURGSTRASSE 21
DE - 44867 BOCHUM
GERMANY
www.kompernass.com
IAN 284993
CAR SMARTPHONE MOUNT
Operating manual and service information
KFZ-SMARTPHONE-HALTERUNG
Bedienungsanleitung und Serviceinformationen
CAR SMARTPHONE MOUNT
SKSH 2 B1
Join the conversation about this product
Here you can share what you think about the SilverCrest IAN 284993 Phone Mount. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.