Manual Rosières RHG 5210 IN Cooker Hood

Manual

ENGLISH

DESCRIPTION

The appliance can be used in both the filtering and ducting version.

In the Filtering version (Fig. 1), the air and vapours conveyed by the appliance are depurated by charcoal filters

and recirculated around the room. ATTENTION: When using the filtering version, charcoal filters must be installed

(the charcoal filters are not supplied). In the Ducting version (Fig. 2), cooking vapours and odours are conveyed

straight outside by a disposal duct which passes through the wall. Use of charcoal filters is therefore unnecessary.

INSTALLATION

Before assembling, in order to manoeuvre the appliance more easily, take off the grease filters: at the handle,

push the stop inwards and pull the filter downwards (Fig. 3).

The following operations are essential for assembly: – Cut a hole in the bottom of the pensile cupboard in

order to settle the appliance (Fig. 4). – Set the power supply near the appliance. – Prepare the air venting hole

if your appliance is to be installed in the ducting version.

To install the appliance, adjust the position of the clasping side springs by means of the proper screws (Fig.5),

according to the thickness of the bored panel to which it is going to be anchored. Insert the appliance in the

pensile cupboard and lock it by means of the side springs. Use the holes which have already been made in the

casing of the appliance to definitively fix it by means of additional 2 screws (Fig. 6).

Ducting version : connect the disposal duct to the air evacuation pipe of the hood. Use a flexible pipe and

lock it to the air evacuation pipe of the hood with a metal hose clamp (pipe and clamp are not provided). Make

the electrical connections.

Filtering version : connect an adequate pipe to the connecting flange of the appliance so that it conveys the air up

to the top of the pensile cupboard (pipe is not provided). Make the electrical connections.

OPERATION

Depending on the model, the unit is equipped with the following controls:

Controls (Fig. 7): A = LIGHT switch. B = MOTOR switch: position 0: motor off; position 1: motor on Ist speed. Position

2: motor on 2nd speed; position 3: motor on 3rd speed. C = Operating motor warning light.

Controls (Fig. 8): A = LIGHT switch. B = MOTOR switch: regulates motor operating speed by means of an electronic

speed variator. C = Operating motor warning light.

Particular care must be paid to the grease filters which must be periodically cleaned in relation to use (at

least once every two months). Remove the grease filters and wash them either by hand or in the dishwasher using

neutral detergent. To take off the grease filters: at the handle, push the stop inwards and pull the filter downwards

(Fig. 3).

When using the filtering version of the appliance, the charcoal filters must be changed according to use

(Fig. 9), usually every six months. Remove the filters rotating them and replace them rotating into the opposite

direction.

Lights:

- To replace the incandescence bulbs remove the grease filters as previously described (Fig.3) so as to be able

to access the inside of the appliance. Remove the fixture: apply a slight pressure on the 2 stops and at the

same time push the fixture downwards (Fig. 10). Unscrew the bulb and replace with another of the same type.

- If the halogen lamps need changing, slacken the ring nut in an anticlockwise direction and remove the bulb

itself (Fig. 11). Replace with a bulb of the same type. CAUTION: Do not handle glass bulb with bare hands.

In case the new halogen bulb does not light up once it is on, disconnect the apparatus for a few seconds.

DEUTSCH

GERÄTEAUSFÜHRUNG

Das Gerät kann sowohl im Umluftbetrieb, als auch im Abluftbetrieb eingesetzt werden.

Im Umluftbetrieb (Abb. 1) wird die Luft zusätzlich durch den (einmotoriges Gerät) / die (zweimotoriges Gerät)

Aktivkohlefilter geleitet und in den Raum zurückgeführt. Pro Motor ist somit ein Kohlefilter erforderlich (Die Kohlefilter

werden nicht mitgeliefert). Im Abluftbetrieb (Abb. 2) wird der Kochdunst durch Abluftrohre ins Freie geleitet.

Kohlefilter sind im Abluftbetrieb nicht erforderlich.

MONTAGE DES GERÄTS

Vor dem Montieren und zur leichteren Handhabung des Gerätes die Fettfilter entfernen: in Übereinstimmung

mit dem Handgriff den Feststeller nach innen stossen und den Filter nach unten ziehen (Abb. 3).

Wesentliche Vorbedingungen zum Montieren: – Am Boden des Hängeschrankes die zum Unterbringen des

Gerätes erforderliche Öffnung ausführen (Abb. 4). – Die elektrische Zuführung nahe am Gerät vorbereiten. – Soll

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Rosières RHG 5210 IN Cooker Hood. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Rosieres. They might be able to provide an original manual. Are you looking for the manual of your Rosières RHG 5210 IN Cooker Hood in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Rosières Cooker Hoods
More manuals of Cooker Hoods

Frequently Asked Questions about Rosières RHG 5210 IN Cooker Hood

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Rosières RBS 94/1 IN Cooker Hood

Manual

Rosières RDM 9000/1 LIN Cooker Hood

Manual

Rosières RHC 940/1 PN Cooker Hood

Manual

Rosières RHG 529 RB Cooker Hood

Manual

Rosières RDC 110 IN Cooker Hood

Manual

Rosières RHP 6700 IN Cooker Hood

Manual

Rosières RHP 975 PN Cooker Hood

Manual

Rosières RHP 67000 LIN Cooker Hood

Related categories