Home > Music & Instruments > Microphones > Renkforce Microphones > Renkforce CU-4 Microphone

Manual Renkforce CU-4 Microphone

Need a manual for your Renkforce CU-4 Microphone? Below you can view and download the PDF manual for free in English. This product currently has 0 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

Commissioning

Never point the microphone onto sound openings of loudspeakers, since this may

lead to acoustic feedback, which may damage the loudspeaker and the computer

connected.

Assembly

• Attach the shock mount on a suitable microphone holder with a 15.8 mm (5/8“) thread.

•

Squeeze the clips on the inner holder of the shock mount together and push the microphone into

the holder. Release the clips to lodge the microphone in the shock mount.

• Loosen the set screw on the shock mount to adjust the microphone to the desired angle.

• Then tighten the set screw by hand.

• To remove the microphone from the shock mount, squeeze again the clips of the inner holder

together and pull the microphone out of the holder.

Audio recording

• Turn down the volume on the computer.

• Connect the supplied USB cable to the microphone.

• Connect the USB plug to a free USB port on your computer.

• Wait until your operating system has recognised and installed the new hardware. This takes

place automatically.

• If necessary, set up the product as an audio resource on your computer.

• Run the appropriate software for sound recordings.

• Adjust the volume of the computer that has the microphone connected to it.

• Unplug the product after use.

Maintenance and cleaning

The studio microphone is maintenance-free.

Please use a soft, dry or slightly damp cloth for cleaning.

Never use aggressive cleaning agents or chemical solutions; this may damage the surface of the

casing.

Disposal

Electronic devices are recyclable material and must not be disposed of in the house-

hold waste!

Please dispose of the product, when it is no longer of use, according to the current

statutory requirements.

Technical data

System requirements ..................................Windows

2000 and later

Connection ....................................................USB 2.0

Sample rate ...................................................16 Bit

Current consumption ..................................2 mA

Impedance ....................................................200 Ohm

Frequency range ..........................................20-20000 Hz

Sensitivity ......................................................-36 ±2 dB (0 dB = 1 V/Pa at 1 kHz)

Max. input level SPL ....................................140 dB (1 kHz at 1% THD)

Directional pattern .......................................Cardioid

Membrane .....................................................25 mm (1“) Gold diaphragm

Working principle .........................................Condenser microphone

Dimensions (Ø x H).......................................51 x 184 mm

Weight ............................................................445 g

Frequency response

Polar patterns

Operating instructions

CU-4 USB Studio Microphone

Item no. 1267828

Intended use

The studio microphone is intended to convert acoustic signals (sound waves) into electrical sig-

nals. It supports podcasting, multimedia presentations, and other applications such as audio re-

cordings.

The USB port may only be connected to appropriate USB ports of computers.

Any use other than as described above is not permitted and can damage the product. In addition,

it can lead to hazards such as short-circuit, ﬁre, etc.

Read the operating instructions carefully and keep them for later reference. If you pass the product

on to a third party, please hand over these operating instructions as well.

No part of the product may be modiﬁed or converted.

The safety instructions must be observed at all times.

This product complies with the applicable national and European requirements. All names of com-

Package contents

• Microphone

• USB cable (3 m)

• Shock mount

• Case

• Operating instructions

Safety instructions

First, read the complete operating instructions carefully, as they contain important

information about proper operation of the device.

Damage due to failure to follow these operating instructions will void the warranty!

We do not assume any liability for any resulting damage!

We do not assume any liability for material and personal damage caused by improper

use or non-compliance with the safety instructions! In such cases, the warranty will

be null and void!

• For safety reasons, any unauthorised conversion and/or modiﬁcation to the product

are not permitted.

• When connecting the microphone, pay attention to the safety instructions of the de-

vice to which it is to be connected.

• Do not expose the product to high temperatures, strong vibrations, dripping water or

water spray.

• Use the product only in a temperate climate, never in a tropical climate.

• This product is not a toy and should be kept out of reach of children.

• Don’t leave packaging material lying around carelessly; it may become a dangerous

plaything for children.

• Handle the product with care; it can be damaged by impact, blows, or accidental

drops, even from a low height.

• Also observe any further safety instructions in the individual chapters of these oper-

ating instructions.

• In commercial institutions, the accident prevention regulations of the Employer’s Li-

ability Insurance Association for Electrical Systems and Operating Facilities are to

be observed.

• If you are unsure how to connect the product properly, or should you have any ques-

tions that are not answered in these operating instructions, please contact our tech-

nical service or consult a professional.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microﬁlming, or the capture in electronic data

processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent

the technical status at the time of printing.

Rating

Let us know what you think about the Renkforce CU-4 Microphone by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the Renkforce CU-4 Microphone?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the Renkforce CU-4 Microphone. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Renkforce CU-4 Microphone. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Renkforce. They might be able to provide an original manual. Are you looking for the manual of your Renkforce CU-4 Microphone in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.