Manual Philips HC3515 Hair Clipper

Manual

1

2

1

2

1

2

1

2

HC3515/15

ENGLISH

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips

oers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

1 Trimming comb 1-23mm

2 Cutting unit

3 Length setting adjustment slider

4 On/o button

5 Charging light

6 Small plug

7 Supply unit

8 Brush

Important safety information

Read this important information carefully before you

use the appliance and save it for future reference.

Danger

- Keep the supply unit dry (Fig. 2).

Warning

- To charge the battery, only use the detachable

supply unit (HQ8505) provided with the

appliance.

- The supply unit contains a transformer. Do not

cut o the supply unit to replace it with another

plug, as this causes a hazardous situation.

- This appliance can be used by children aged from

8 years and above and persons with reduced

physical, sensory or mental capabilities or lack

of experience and knowledge if they have been

given supervision or instruction concerning use of

the appliance in a safe way and understand the

hazards involved. Children shall not play with the

appliance. Cleaning and user maintenance shall

not be made by children without supervision.

- Always check the appliance before you use it. Do

not use the appliance if it is damaged, as this may

cause injury. Always replace a damaged part with

one of the original type.

- Do not open the appliance to replace the

rechargeable battery.

Caution

- This appliance is not washable. Never immerse

the appliance in water and do not rinse it under

the tap (Fig. 2).

- Only use this appliance for its intended purpose

as shown in the user manual.

- For hygienic reasons, the appliance should only

be used by one person.

- Never use compressed air, scouring pads,

abrasive cleaning agents or aggressive liquids

such as petrol or acetone to clean the appliance.

- Do not use the supply unit in or near wall sockets

that contain an electric air freshener to prevent

irreparable damage to the supply unit.

Electromagnetic elds (EMF)

This Philips appliance complies with all applicable

standards and regulations regarding exposure to

electromagnetic elds.

General

- The supply unit is suitable for mains voltages

ranging from 100 to 240 volts.

- The supply unit transforms 100-240 volts to a

safe low voltage of less than 24 volts.

Charging

Charge the appliance fully before you use it for the

rst time or if you have not used it for a long time.

It takes approximately 8 hours to fully charge the

appliance.

When the appliance is fully charged, the appliance

has a cordless operating time of up to 45 minutes.

Note: After charging the appliance once fully for the

rst time, you can also use the appliance directly

from the mains. Simply connect the appliance to the

mains.

Charging with the supply unit

1 Make sure the appliance is switched o (Fig. 3).

2 Insert the small plug into the appliance (Fig. 4).

3 Put the supply unit in the wall socket.

4 When the appliance is charging, the charging light

lights up continuously (Fig. 5).

5 After charging, remove the supply unit from the

wall socket and pull the small plug out of the

appliance.

Optimising the lifetime of the rechargeable

battery

When you have charged the appliance for the rst

time, we advise you to use it until the battery is

completely empty. Continue to use the appliance

until the motor almost stops operating during a

session. Then recharge the battery. Follow this

procedure at least twice a year.

Using the appliance

The hair length settings are indicated in millimeters,

the comb cuts the hair to a length of 1mm to 23mm.

The settings correspond to the remaining hair length

after trimming.

Warning: Be careful when you trim for the rst

time. Do not move the trimmer too fast. Make

smooth and gentle movements.

Tip: Start trimming at a high length setting and

reduce the length setting gradually until you have

reached the desired hair length.

Trimming with comb

1 Attach the trimming comb to the appliance (Fig.

6).

2 Slide the length setting adjustment slider to the

desired length setting (Fig. 7).

Note: When you trim for the rst time, start at

the highest length setting to familiarise yourself

with the appliance.

3 Switch on the appliance (Fig. 8).

4 Move the appliance slowly and with light

pressure against the direction of hair growth　

(Fig. 9).

Note: Make sure that the at part of the comb

always stays in contact with the skin to obtain

an even result (Fig. 10).

Trimming without comb

Use the trimmer without the trimming comb to trim

hair close to the skin (0.5 mm) or to contour the

neckline and sideburns.

Caution: Be careful when you trim without comb

because the cutting unit removes every hair it

touches.

1 Pull the comb o the appliance (Fig. 11).

2 Switch on the appliance (Fig. 8).

3 Touch the hair lightly with the trimmer. Make

　 well-controlled movements (Fig. 12).

Cleaning

Warning: Never use scouring pads, abrasive

cleaning agents or aggressive liquids such as

petrol or acetone to clean the appliance.

Warning:Never immerse the appliance in　

water, or rinse it under the tap.

Note: Only the cutting element and the comb can

be cleaned with water.

1 Make sure that the appliance is switched o and

　 disconnected from the mains.

2 Wipe the housing of the appliance with a dry

　 cloth.

3 Remove the comb. Clean it with the cleaning

　 brush and rinse with water (Fig. 13).

4 Press the release button. The cutting unit comes

　 o the appliance (Fig. 14).

5 Clean the cutting unit with the cleaning brush or

　 rinse it under the tap (Fig. 15).

6 Clean the inside of the appliance with the

　 cleaning brush (Fig. 16).

7 Shake o excess water. To reattach the cutting

　 unit, insert the lug of the cutting unit into the

guiding slot.

8 Insert the lug of the cutting unit into the guiding

　 slot and push the cutting unit back onto the

　 appliance (Fig. 17).

Replacement

Only replace a worn or damaged cutting unit with an

original Philips cutting unit, available from authorised

Philips service centre.

1 Press the release button. The cutting unit comes

　 o the appliance (Fig. 14).

2 Insert the lug of the new cutting unit into the

　 guiding slot and push the cutting unit onto the

　 appliance (Fig. 17).

Ordering accessories

To buy accessories or spare parts, visit

www.shop.philips.com/service or go to your Philips

dealer. You can also contact the Philips Consumer

Care Center in your country (see the international

warranty leaet for contact details).

Recycling

- Do not throw away the product with the normal

household waste at the end of its life, but hand

it in at an ocial collection point for recycling. By

doing this, you help to preserve the environment.

- This product contains a built-in rechargeable

battery which shall not be disposed of with

normal household waste. Please take your

product to an ocial collection point or a Philips

service center to have a professional remove the

rechargeable battery.

- Follow your country’s rules for the separate

collection of electrical and electronic products

and rechargeable batteries. Correct disposal

helps prevent negative consequences for the

environment and human health.

Removing the rechargeable battery

Only remove the rechargeable battery when

you discard the product. Before you remove

the battery, make sure that the product is

disconnected from the wall socket and that the

battery is completely empty.

Take any necessary safety precautions when

you handle tools to open the product and

whenyou dispose of the rechargeable battery.

The battery must be removed from the

appliance before it is scrapped.

Removing the rechargeable battery

1 Disconnect the appliance from the mains and

　 let the appliance operate until the motor stops.

2 Remove the length adjustment slider with a

　 athead screwdriver (Fig. 18).

3 Press the release button. The cutting unit

　 comes o the appliance (Fig. 19).

4 Insert a athead screwdriver into the slots

　 between the front and back panel. Tilt the

　 handle of the screwdriver to separate the frond

　 and back panel(Fig. 20).

5 continue this step along the edge of the front

　 panel to separate the front panel from the back

　 panel (Fig. 21).

6 Use a athead screwdriver to unscrew the

　 screws next to the length adjustment slider (Fig.

22).

7 Pull the inner body from the back panel (Fig.

　 23).

8 Pull the circuit board from the inner body (Fig.

　 24)

9 Cut the wires to separate the circuit board from

　 the inner body (Fig. 25).

10 Cut the connectors from the batteries and

　 remove the batteries (Fig. 26).

Danger: Do not connect the appliance to the

mains again after you have opened it.

Warranty and support

If you need information or support, please visit

www.philips.com/support or read the international

warranty leaet.

Troubleshooting

This chapter summarizes the most common

problems you could encounter with the appliance.

If you are unable to solve the problem with the

information below, visit www.philips.com/support

for a list of frequently asked questions or contact the

Consumer Care Center in your country.

Problem Possible

cause

Solution

The

appliance

produces

an uneven

cutting

result.

The comb

does not

touch the

skin when

you move

the appliance

through the

hair.

Make sure the

comb is always

fully in contact with

the skin when you

move the appliance

through the hair.

You only

move the

appliance in

one direction.

Because not

all hairs grow

in the same

direction, move

the appliance in

dierent directions

(upwards,

downwards and

across).

The setting

of the comb

has changed

during

trimming.

Check the setting

of the comb. If you

push the appliance

too hard onto

the scalp, you

may accidentally

change the setting

of the comb.

The comb

is not

assembled

correctly.

Detach the comb

and reattach it.

The cutting

performance

decreases

when the

cutting unit

and the comb

are dirty.

Clean the cutting

unit and the comb

(see 'Cleaning').

The

appliance

does not

work when

I switch it

on.

The

rechargeable

battery is

empty

Charge the

appliance. Make

sure that the small

plug is inserted

into the appliance

properly and

the adapter is

connected to

the wall socket

properly.

1

1-23mm

1

2

3

8

7

4

5 6

2

3

5

7

6

8

10

9

11

13

12

14

16

15

17

19

18

20

22

21

26

23

25

24

4

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Philips HC3515 Hair Clipper. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Philips. They might be able to provide an original manual. Are you looking for the manual of your Philips HC3515 Hair Clipper in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Philips Hair Clippers
More manuals of Hair Clippers

Frequently Asked Questions about Philips HC3515 Hair Clipper

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Philips HC3516 Hair Clipper

Manual

Philips QC5053 Hair Clipper

Manual

Philips QG3080 Hair Clipper

Manual

Philips QC5582 Headgroom Hair Clipper

Manual

Philips HC3409 Hair Clipper

Manual

Philips HC3535 Hair Clipper

Manual

Philips QC5360 Hair Clipper

Manual

Philips QC5050 Hair Clipper

Related categories