Manual Inno BRA220 Roof Box

Manual

5411-71089G

1

2

3

5

6

8

These instructions are for the installation and use of the Inno carrier system attachment. After reading this manual, keep it in a safe place along with the

installation instructions for the rest of your carrier system.

If using an aftermarket base rack system, make sure that it is installed properly

according to the procedures described in the installation instructions for that rack.

The distance between the front and rear crossbars should be at least 60cm ( 2 feet )

Cargo Box BRA220R Installation Instructions

CAUTION

PRECAUTIONS

Do not overload your cargo box. Maximum load

capacity varies by vehicle. Check the appropriate

limits for your car in the Fit Guide and your vehicle

owner's manual and determine your maximum

loading capacity with the formula below.

The Cargo box includes the parts listed below. Verify that they are included with the

carrier you have purchased. In the event any of these is missing, contact our service

center as listed at the end of this manual.

4

7

Before driving the vehicle, shake the rack in

all directions to ensure that there is no

looseness in any of the mounting knobs and

screws. Retighten any loose knobs or screws.

Max load of

cargo box

1

10 lbs

Max load of

vehicle or

cross bar

Weight of

cargo box

OR

-

Ins

t

a

lla

tion

I

n

s

t

r

u

ctio

n

s

Use the lower of the 2 options below

Parts

Rooftop Box

QtyNO.

Knob

U-Bolt

Plate

Strap

Hole Covering

Molding

1

8

4

4

2

Strap Hook 2

2

1

2

3

4

5

6

9

10

Key

Manual Instruction

2

1

7

8

6

1

2

3

4

5

6

7

9

10

8

Temporarily put the Box on cross bars. And ①Insert key, turn clockwise and ②

push button to open the Box.

pushbutton

key

2

Adjust the location of the Box to align with holes at A.

Rooftop Box

Cross Bar

A B

Front

Attach the Box to front cross bar with Plate, U-Bolt and Knobs. Make sure that

the ring on the Plate is on the side nearest the side of box.

U-Bolt

Ring

Plate

Cross Bar

A

Front

Ring

Plate

Cross Bar

B

Rear

U-Bolt

Tighten right and left knobs alternately to secure the Box to cross bar.

U-Bolt

Knob

Front

U-Bolt

Knobs

Rear

Make sure to tighten the right

and left knobs evenly so that

the U-bolt sits square with the

bar.

If U-bolt is not tightened

correctly, it may allow the box

to come loose.

Warning

U-Bolt

Cargo Box

Cross Bar

Front - Place plugs into the 6 unused holes to seal

Rear - Trim Molding to the proper size and insert into slot.

U-Bolt

Plug

Front

U-Bolt

Cut Molding to this size.

Molding

Rear

Thread Strap trough two Rings on each side of the box and

fasten. Attach Strap Hooks inside box lid just above Straps.

StrapHook

BoxLid

Buckle

Strap

BuckleRing

Push Box in all directions to make sure that there is no

loosenesss. If you notice any play in the box, retighten 8 Knobs.

10

12

11

9

Insert Key into key cylinder and turn it clockwise to "Open" position. Lift Box Lid by

pushing release button.

Release button

Box lid

1

2

Key

Leave Key in key cylinder until Box is closed to avoid locking it in the box

accidentally.

Caution

Strap

Strap Hook

Buckle

Unfasten Buckle and hang Straps on Strap Hooks to keep them out of the way while

loading. Load cargo. Unhook Straps and fasten it to secure cargo from moving while

driving.

To close lid, make sure that Key is in the OPEN position. Make sure that Hooks line

up with latches and close Box all the way.

Hook latches

Hook

Try to lift the lid at the latch points shown below to make sure that the hooks

have full engaged with the latches.

Turn Key counter clockwise to the CLOSE position.

Check at these points

Genuine Inno Replacement Parts

Specifications and the appearance of the carrier system and genuine replacement

parts are subject to change without prior notice in the interest of product

improvement.

The following genuine replacement parts are available for this Inno carrier system

component. Specify the part number when ordering parts from your dealer.

Note

M

a

n

u

a

l

I

N

N

O

ISP952 Strap

(2 pack)

ISP682 Strap Hook

(2 pack)

ISP193 Molding

(2 pack)

Key(Verify

Key number)

U-Bolt Knobs (2 pack) Plate

Instruction Manual

Fit Kit

ISP588 Hole Plugs

(4 pack)

Contact Information

If you have any questions or comments, please contact us at the service center listed below. CarMate shall not be held liable for any accidents or incidental losses arising

from improper installation or use, nor for those arising from installation or use after the customer has made any change to the system's original configuration or specifications.

Car Mate USA

383 Van Ness Ave., Suite 1603

Torrance, CA

www.innoracks.com

[email protected]

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Inno BRA220 Roof Box. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Inno. They might be able to provide an original manual. Are you looking for the manual of your Inno BRA220 Roof Box in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Inno Roof Boxes
More manuals of Roof Boxes

Frequently Asked Questions about Inno BRA220 Roof Box

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.