6 7
CAUTION: Turn OFF and unplug the air purifier
To remove the ifD
®
Micro-filter:
• Push the Filter Release button and then gently lift the
filter assembly (Fig. 10a & 10b). The filter assembly will
only release if the button is pushed.
• Remove the pre-filter press the top tab to the relase the
pre-filter (Fig. 14).
• With one hand, hold the air purifier frame and use other
hand to grasp ifD
®
filter and pull out (Fig. 14b).
To clean the ifD
®
Micro-filter:
The ifD
®
filter should be cleaned approximately every 3 months.
After removing the ifD
®
filter from the air purifier, follow the steps below to
clean the ifD
®
filter.
• VACUUM: (Optional) After removing the ifD
®
Micro-filter from the air purifier,
gently run a vacuum cleaner with a nozzle or brush attachment along the filter
to pick-up tiny particles (Fig. 11). Repeat on both sides.
WASHING:
If you choose not to vacuum the filter first, please follow the steps below to wash
the ifD
®
Micro-filter.
• Remove the ifD
®
Micro-filter from the unit.
• You can simply rinse the ifD
®
Micro-filter under the faucet, or for more thorough
cleaning, fill the sink with lukewarm water and add a few drops of mild dish
soap (Fig. 12).
• Gently swish the filter in the soap solution to clean.
• Soak the filter for 2-3 minutes. Do not leave for an extended period of time.
• Rinse the filter with clean tap water.
DRYING:
• Shake the filter to remove any excess water.
• Place the filter with the honeycomb side down on a plush towel (Fig. 13).
• Note that the filter may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the ifD
®
Micro-filter to dry for a few hours or overnight.
• When the ifD
®
Micro-filter is completely dry, place back into the air purifier.
Make sure you insert the filter according to the directional arrows on the filter.
To place the ifD
®
filter back into the housing, align the filter assemby with the
opening at top of unit and insert. Press until it is flush and you hear an audible
“click”.
Fig. 10a
Fig. 10b
Fig. 11
Fig. 12
Fig. 13
REMOVING / CLEANING THE IFD
®
MICRO-FILTER (ALL MODELS)
•
To replace washable pre-filters with the Odor-Lock
™
pre-
filters, remove the standard washable pre-filter assembly
by pushing on the top tab (Fig.17).
•
To insert the Odor-Lock
™
pre-filters into the pre-filter
frame, line the tabs on the pre-filter up with the frame
notches and snap into place (Fig.18).
•
Install the Odor-Lock
™
filter assembly by inserting the
lower tab of the pre-filter frame into the filter assembly
until you hear a “click” (Fig. 19.
•
Align the complete filter assembly with the opening in
the unit and insert back into the unit (Fig. 20).
NOTE: The Odor-Lock
™
filters are not washable.
NOTE: If Odor-Lock
TM
is used in lieu of the permanent
washable pre-filter, it will need to be replaced approximately
every 3 months and should be installed the same location
after the washable pre-filter is removed.
INSTALLING THE ODOR-LOCK
™
PRE-FILTER(S) (HFD-014, HD010WHS, HD010LHS, HD010RHS ONLY)
Fig. 17
Fig. 18
Fig. 19 Fig. 20
REMOVING/CLEANING THE WASHABLE PRE-FILTER (ALL MODELS)
To remove the pre-filter:
•
Press the top tab to release the pre-filter from the filter
assembly (Fig. 14).
•
Hold the frame steady from the side while pushing in the
center of each pre-filter from the back side of the frame
(Fig.15).
•
Separate the pre-filter from the frame and you can then
pull it completely away from the frame (it will snap out).
•
If using the Odor-Lock
TM
adsorbing pre-filter, it is recommended that you store the original washable
pre-filter in the event that you decide to use it in the future.
Fig. 14
Fig. 16
To clean the pre-filter:
The particle pre-filter helps pick-up large airborne particles that enter the filter.
This pre-filter can be periodically removed and shaken or vacuumed clean.
Alternatively, it can be rinsed by hand under warm water to clean (Fig. 16).
Let the pre-filter dry completely before inserting it back into the unit.
Fig. 15
CAUTION:
• Never place a wet ifD
®
Micro-filter in your air purifier.
• The ifD
®
Mirco-filter is NOT dishwasher safe. Do not place the ifD
®
Micro-filter
in a dishwasher or subject it to other extreme hot water conditions.
• Do not use any solvents, strong cleaning agents or flammable liquids to clean
the ifD
®
Micro-filter.
Fig. 14
Fig. 14b
Join the conversation about this product
Here you can share what you think about the Honeywell HFD-010-2 QuietClean Air Purifier. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.