-14-
Model G0555/G0555P (Mfg. Since 5/11)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Shipping Inventory: (Figures 4–6) Qty
A. Bandsaw Assembly .....................................1
B. Upper Stand Braces ....................................2
C. Stand Top ....................................................1
D. Miter Gauge Assembly ................................1
E. Stand Sides .................................................2
F. Table w/Insert & Table Pin ..........................1
G. Table Trunnion .............................................1
H. Table Lock Knobs
3
⁄8"-16 .............................2
I. Lower Stand Braces ....................................2
J. Front Fence Rail ..........................................1
K. Rear Fence Rail ..........................................1
L. Fence Assembly ..........................................1
M. Hardware (Not Shown):
— Hex Bolts M6-1 x 16 (Stand) ................. 16
— Flat Washers 6mm (Stand) ................... 16
— Flange Nuts M6-1 (Stand) .................... 16
— Stand Feet
3
⁄8"-16 x 2" (Stand) ................ 4
— Hex Nuts
3
⁄8"-16 (Stand Feet) .................. 8
— Flat Washers
3
⁄8" (Stand Feet) ................ 8
— Carriage Bolts M8-1.25 x 16 (Stand) ...... 8
— Flange Nuts M8-1.25 (Stand) .................. 8
— Hex Bolts M8-1.25 x 35 (Bandsaw) ........ 4
— Flat Washers 8mm (Bandsaw) ............... 8
— Lock Washers 8mm (Bandsaw) .............. 4
— Hex Nuts M8-1.25 (Bandsaw) ................. 4
— Hex Bolts M8-1.25 x 30 (Trunnion) ......... 2
— Lock Washers 8mm (Trunnion) ............... 2
— Hex Bolt M8-1.25 x 80 (Positive Stop) .... 1
— Hex Nut M8-1.25 (Positive Stop) ............. 1
— Fence Stand-Off M6-1 x 20 (Fence) ....... 1
— Lock Handle M8-1.25 x 20 (Fence) ......... 1
—Cap Screws M6-1 x 16 Black (Fence) .... 2
— Hex Bolts M6-1 x 20 Black (Fence) ........ 2
— Lock Washers 6mm Black (Fence) ......... 2
— Flat Washers 6mm Black (Fence) .......... 2
—Hex Nut M8-1.25 Black (Fence) .............. 1
— Hex Nut M6-1 Black (Fence)................... 1
Figure 4. Bandsaw assembly.
A
Figure 5. Other components.
B
E
I
H
C
D
G
F
Figure 6. Fence components.
J
K
L
Join the conversation about this product
Here you can share what you think about the Grizzly G0555 Bandsaw. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.