Manual Crivit IAN 307565 Bicycle Light

Manual

DE/AT/CH

GB/IE/NI

GB/IE/NIGB/IE/NI

GB/IE/NIGB/IE/NIGB/IE/NI

To help protect the environment, please dispose of the product properly when it has reached

the end of its useful life, not in the household waste. Please contact your municipality for infor

-

mation on collection facilities and their opening hours.

Defective or used rechargeable batteries must be recycled according to Directive 2006/66/EC and its

amendments. Return rechargeable batteries and / or the product to the recycling facilities provided.

Improper disposal of rechargeable batteries may result in environmental

damage!

Rechargeable batteries may not be disposed with household waste. They may contain toxic heavy metals

and are subject to hazardous waste regulations. The chemical symbols of the heavy metals are: Cd =

cadmium, Hg = mercury, Pb = lead. Therefore dispose of used rechargeable batteries through a local

collection point.

Improper disposal of rechargeable batteries destroys valuable resources and the hazardous substances

in the rechargeable batteries may pose a significant danger to human health and environment. Separate

collection/disposal of rechargeable batteries prevents dangers to human health and environment, and

valuable resources are regained by recycling.

7. Warranty

Dear customer,

The warranty for this product is 3 years from the date of purchase. In the event of product defects, you

have legal rights against the retailer of this product. Your legal rights are not limited in any way by our

warranty detailed below.

7.1 Warranty terms

The warranty period begins on the date of purchase. Please keep the original receipt in a safe place. This

document is required as your proof of purchase. Should this device show any fault in materials or manu

-

facture within three years from date of purchase, it will be repaired or replaced - at our choice - by us free

of charge. This warranty is conditional on the defective product and the receipt of purchase being presented

within the three year warranty period, and on there being a brief written description of the nature of the

defect and of the date it arose. If the defect is covered by our warranty, we will return the repaired device

or replacement thereof. A repair or exchange of the device does not extend a new warranty period. Repairs

made under warranty do not extend the warranty period. This also applies to replaced and repaired parts.

Any damage or defects present at the time of purchase must be reported immediately after unpacking the

appliance. Repairs made after the warranty period has expired are subject to payment.

7.2 Extent of warranty

The product has been manufactured to strict quality guidelines and meticulously examined before delivery.

The warranty applies to defects in material or manufacture. This guarantee does not apply to product parts

which are subject to normal wear and tear and can be regarded as wearing parts, or for damage to break

-

able parts, e.g., switch, rechargeable batteries, or parts which are made of glass. This warranty becomes

4.2 Tail light with brake indicator function

9

(3 red LEDs light up for approx. 3 seconds during the braking process)

On/Off switch

10

press once Day-mode

Tail light is off.

Brake indicator function is active, day-mode display

11b

flashes green.

press twice Night-mode

Tail light is on.

Brake indicator function is active.

When the battery monitor

11a

for the tail light comes on, it will continue to emit light for at least 30 minutes.

4.3 Charging the headlight / tail light (see Fig. A + D)

Remove the rubber cover from the battery charging socket

17

and connect the USB cable

16

to the

battery charging socket

17

.

Then connect the USB connector on the USB cable

16

to a computer / laptop / standard USB-

charger with 5 V DC and 500-1000mA. Using charger with different specifications can damage the

batteries, and in turn the headlight and tail light. This will void the warranty.

The headlight

1

and tail light

9

are equipped with a battery monitor. The battery monitor

2a

for

the headlight flashes red when the batteries are low and need to be recharged. The battery monitor

11a

for the tail light lights up red when the batteries are low and need to be recharged. The battery

monitor lights up green whilst charging. When the rechargeable batteries are ready for use, all 4

charging LEDs of the headlight rechargeable battery control system light up continuously and the

rechargeable battery control system on the tail light extinguishes. The headlight

1

and tail light

9

are ready for use.

For the built-in batteries to operate at full power, be sure to charge the headlight battery for at least

6 hours when charging for the first time (tail light battery: at least 5 hours). Please do not stop charg-

ing sooner, even if the LED is already extinguished. After this, the recommended charging time for the

headlight is approx. 3.5 hours (recommended charging time for the tail light is 2.5 hours).

5. Cleaning and care

Never fully immerse the headlight and tail light in water. Do not use corrosive or abrasive cleaning

agents. These will damage the product.

Use a dry, lint-free cloth for cleaning and care.

6. Disposal

The packaging is made from environmentally-friendly materials which can be disposed of through your

local recycling facilities.

Contact your local waste disposal authority for more details of how to dispose of your worn-out product.

4. Operation

4.1 Switching on / off

The headlight

1

has three brightness settings.

On / Off switch

4

press once

Auto mode: The headlight

1

is equipped with a sensor

5

which

automatically adjusts the brightness of the headlight

1

to the sur-

roundings. When the sensor is active

5

(auto-mode), the sensor

control light

3

flashes blue.

press twice Power mode (60 Lux) for riding in unlit areas

press three times Standard mode (30 Lux) for riding in lit areas

press four times Eco mode (15 Lux) for riding in well-lit areas

press five times Power off

Mode display

2b

Sensor mode lowest LED flashes

(The upper 3 LEDs display the light intensity)

4 LEDs 60 lux

3 LEDs 30 lux

2 LEDs 15 lux

Battery status: Operating mode of the battery monitor

100 % - 75 % 4 green LEDs light up

75 % - 50 % 3 green LEDs light up

50 % - 25 % 2 green LEDs light up

25 % - 10 % 1 green LED lights up

10 % - 0 % 1 red LED flashes

When the battery monitor

2a

for the headlight comes on, it will continue to emit light for at least 30 minutes.

2.1 Rechargeable battery safety notes

CAUTION! DANGER OF EXPLOSION! Keep rechargeable batteries away from

children, do not throw rechargeable batteries into fire, do not short-circuit and do not take

apart.

Failure to observe this may discharge the rechargeable battery beyond their end voltage. This poses

a risk of leaking.

Avoid contact with the skin, eyes and mucous membranes if fluid has leaked from the rechargeable

batteries. In the event of contact with battery acid, thoroughly flush the affected area with clean wa

-

ter and seek immediate medical attention.

Note: If the red LED on the battery monitor

2a

,

11a

lights up on the headlight

1

or tail light

9

,

recharge the batteries promptly.

3. Installation

3.1 Installing the headlight (see Fig. A)

Position the bracket

6

in the desired location on the handlebar.

Secure the bracket

6

to the handlebar using the rubber tab

7

. When doing so, ensure that there

are no objects in front of the headlight

1

.

Apply tension to the rubber tab

7

and hook in. To prevent damage, do not use tools for this step.

To adjust the optimum angle to the direction of travel, turn the headlight

1

to the correct position

(see Fig. A).

Slide the headlight

1

into the bracket

6

until you hear it lock into place.

To remove, press the headlight lock

8

and slide the headlight

1

forward out of the bracket

6

.

ATTENTION! Routinely check the headlamp adjustment. The light cone must point straight ahead, in

the direction of travel, and must not be adjusted too high so as not to blind oncoming traffic.

3.2 Installing the tail light (see Fig. B)

Secure the bracket

12

in the desired location on the seat post or the rear seat stays

13

. Ensure the

are no objects blocking the tail light

9

.

Apply tension to the rubber tab

13

and hook in. To prevent damage, do not use tools for this step.

Loosen the star screw

15

on the bracket

12

and adjust to the desired angle.

Then tighten the screw hand tight. To prevent damage, do not use tools for this step.

Slide the tail light

9

into the bracket

12

until you hear it lock into place. Be sure to install the tail

light as shown in Fig. B.

To remove the tail light

9

, press the tail light lock

14

and take off the tail light

9

.

ATTENTION! The tail lamp must be installed and adjusted so the reference axis is parallel to the

median longitudinal plane of the vehicle and parallel to the road.

4

Headlight on/off switch

5

Headlight sensor

6

Headlight bracket

7

Rubber tab for headlight bracket

8

Headlight lock

9

Tail light

10

Tail light on / off switch

11b

Day-mode display

12

Tail light bracket

13

Rubber tab for tail light bracket

14

Tail light lock

15

Tail light bracket star screw

16

USB cable including USB plug

17

Charging port (headlight and tail light)

11a

Tail light battery monitor

1.3 Scope of delivery

1 Headlight

1 Tail light

1 Headlight bracket

1 Tail light bracket

1 USB cable

1 Instructions for assembly and use

1.4 Technical data

Headlight (auto-dimming) Tail light

Model designation: LI-3B / XC-266A Model designation: LR-2B / XC-249P

Rated power: 2 W Rated power: 0.2 W

IP rating: IP44 per DIN EN 60529 IP rating: IP44 per DIN EN 60529

Li-ion rechargeable battery: 1300 mAh, 3.7 V Li-ion rechargeable

battery: 300 mAh, 3.7 V

2. Safety notes

DANGER TO LIFE AND RISK OF ACCIDENT FOR INFANTS

AND CHILDREN! Never leave children unsupervised with the packing material due to

the suffocation hazard posed by swallowing parts thereof. Children frequently underesti

-

mate the dangers.

Always keep the product out of the reach of children. This product is not a toy!

This product may be used by children aged 8 years and up, as well as by persons with reduced

physical, sensory or mental capacities or lacking experience and knowledge when supervised or in

-

structed in safe product use and they understand the associated risks. Do not allow children to play

with the product. Cleaning and user maintenance must not be performed by children without supervi

-

sion. Please note, damages caused by incorrect handling, non-compliance with the instructions for

use or interference with the device by unauthorised individuals are excluded from the warranty.

Never take the product apart. Improper repairs may result in considerable danger to the user. Always

have repairs performed by a professional. The LED lights cannot be replaced.

DANGER TO LIFE AND RISK OF ACCIDENTS! Using an incorrect charger can

result in headlight

1

and tail light

9

damage, overheating and even explosion. This will void the

warranty.

List of pictograms used

Read the instructions!

USB – Universal Serial Bus – interface

to port, e.g. on a computer (charging

only)

Danger to life and risk of accidents

for infants and children!

K XXXXX

German Federal Motor Transport

Authority test symbol (K followed by

approval number)

Observe warnings and safety

information!

Dispose of the product and packaging

in an environmentally-friendly manner

Caution! Danger of explosion!

21

PAP

Recycling code for the disposal of

cardboard

Symbol identifying electrical and

electronic devices

Product meets the applicable European

product-specific directives

Improper disposal of rechargeable

batteries may result in

environmental damage!

01

PET

Recycling code for the disposal of

polyester fibres and films

Splash-proof, protection against

foreign bodies

LED Bike Light Set

1. Introduction

Congratulations on the purchase of your new product. You have chosen a high-quality pro-

duct. The instructions for use are a part of this product. It contains important safety, assembly

and disposal information. Before using the product, please familiarise yourself with all safety

notes and instructions for use. The product must only be used as described and for the specified fields of

application. When passing the product on to others, be sure to also include all documentation.

1.1 Intended use

This product is suitable for lighting the roadway whilst cycling. The LED bike light set is approved as exclusive

lighting for all bicycles. Light distribution must not be impaired by other bicycle parts or cargo. The product is

intended for outdoor use. Any use not described above or product modification is prohibited and can

result in injuries and product damage. The manufacturer assumes no liability for damage resulting from

improper use. This product is not intended for commercial use.

1.2 Parts description

1

Headlight

2a

Headlight battery monitor

2b

Headlight mode display

3

Headlight sensor indicator light

IAN 307565

Artikel-Nr. / Item No. 14149

LED BIKE LIGHT SET

LED-FAHRRADLEUCHTEN-SET

Bedienungs- und Sicherheitshinweise

B

10

14

121513

D

16

17

A

7

1

8

ESC

F1

~

`

!

1

F2

@

TAB

CAPS

USB

16

accu

mode

4

5

6

C

9

2b

2a

2a

2b

11a11b

3

17

LED BIKE LIGHT SET

Operation and safety notes

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Crivit IAN 307565 Bicycle Light. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Crivit. They might be able to provide an original manual. Are you looking for the manual of your Crivit IAN 307565 Bicycle Light in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Crivit Bicycle Lights
More manuals of Bicycle Lights

Frequently Asked Questions about Crivit IAN 307565 Bicycle Light

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Crivit IAN 294079 Bicycle Light

Manual

Crivit IAN 89265 Bicycle Light

Manual

Crivit IAN 298712 Bicycle Light

Manual

Crivit IAN 278494 Bicycle Light

Manual

Crivit IAN 314568 Bicycle Light

Manual

Crivit IAN 275453 Bicycle Light

Manual

Crivit IAN 315387 Bicycle Light

Manual

Crivit IAN 285900 Bicycle Light

Related categories