5
ELECTRICAL CONNECTIONS
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through
an approved 13 amp BS 1363 plug, or a suitably fused isolator switch.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the flexible lead of this appliance may not correspond with the
coloured markings identifying terminals in your plug proceed as follows:
• Connect GREEN & YELLOW cord to terminal marked with a letter “E” or Earth
symbol “ ” or coloured GREEN or GREEN & YELLOW.
• Connect BROWN cord to terminal marked with a letter “L” or coloured RED.
• Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e. non-
rewireable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a danger of
electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local dealer or most electrical
stockists.
FUSE RATING
The fuse in the plug must be replaced with one of the same rating (13 amps) and
this replacement must be approved to BS1362.
We recommend that this machine is connected to the mains supply via a Residual
Current Device (RCD)
If in any doubt, DO NOT attempt any connections or repairs yourself. Consult a
qualified electrician, your Clarke dealer, or CLARKE International Service Dep’t on
Pioneer 110Volt model
Connect the mains lead to a suitable 110V (50Hz) electrical supply through an
approved plug or a suitably fused isolator switch.
If using a portable 110V transformer, make sure it has a rated capacity sufficient
to take a 13 amp load.
12
SPARE PARTS
No. Description Qty Part No
1 Head Bolt 4 FN014002021
2 Washer 4 FN014005008
3 Manifold 1 FN111015000
4 Cylinder Head 1 FN116022002
5 Air Cleaner 1 FN317007000
6 Head Gasket upper 1 FN116022009
7 Valve assy 1 FN116022013
8 n/a
9 n/a
10 Head Gasket Lower 1 FN116022010
11 Cylinder Block 1 FN116022001
12 Bolt 2 FN014001044
13 Gasket 1 FN116022002
14 Piston Ring Set 1 FN216022002
14 Piston Ring Set 1 FN216022004
15 Piston 1 FN116022004
15 Piston 1 FN116022901
15 Piston 1 FN116022040
16 Gudgeon Pin 1 FN116022040
17 Circlip 2 FN015001000
18 Piston Assy 1 FN416022040
18 Piston Assy 1 FN416022901
19 Con-rod 1 FN416022005
20 Washer 1 FN014005006
21 Motor Housing 1 FN116022051
22 Bearing 1 FN033018000
23 Shaft 1 FN116022011
24 Bearing 1 FN033019000
26 Seal 1 FN010013000
27 Dipstick 1 FN012008000
28 End Housing 1 FN016032014
29 Screw 11 FN014006023
30 Bolt 2 FN116011038
31 Capacitor 1 FN009200014
32 Rotor 1 FN116022026
33 Stator 1 FN416022604
34 Bearing 1 FN033005000
35 End Casing 1 FN116011001
36 Nut 2 FN014003002
37 Fan 1 FN116032004
38 Fan Cover 1 FN116032003
39 Circlip 1 FN015015000
41 Motor Cover 1 FN116022014
- Full set of Gaskets 1 FN216032001
Join the conversation about this product
Here you can share what you think about the Clarke Pioneer 105 Compressor. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.