Home > Household appliances > Kettles > Carlton Kettles > Carlton C17JKS09 Kettle

Manual Carlton C17JKS09 Kettle

Need a manual for your Carlton C17JKS09 Kettle? Below you can view and download the PDF manual for free in English. This product currently has 5 frequently asked questions, 0 comments and has 0 votes. If this is not the manual you want, please contact us.

Is your product defective and the manual offers no solution? Go to a Repair Café for free repair services.

Manual

Before using this appliance ensure that the voltage of your electricity supply is

suitable for that indicated on the rating plate of the appliance.

THIS APPLIANCE MUST BE EARTHED.

The ultimate disconnection from the power source is the mains plug. Always make

sure it is easily accessible to be unplugged in the event of an emergency.

This appliance is tted with a fused three pin mains plug to BS 1363 which will be

suitable for use in all houses tted with mains sockets to current specications.

If the tted mains plug is not suitable, remove the fuse and dispose of the mains

plug safely, immediately after removing it from the mains cable.

Fitting a new mains plug

If for any reason you need to t a new mains plug, the mains cable must be

connected as shown here. The wires in the mains cable tted to this appliance are

coloured in accordance with the following code:

If the colours of the wires in the mains cable of this appliance do not correspond

with the coloured markings identifying the terminals in your mains plug, proceed as

follows:

The wire which is coloured

• Green and Yellow: MUST be connected to the terminal which is marked with the

letter E (Earth) or symbol or coloured Green.

• Blue: MUST be connected to the terminal which is marked with the letter N

(Neutral) or coloured Blue or Black.

• Brown MUST be connected to the terminal which is marked with the letter L (Live)

or coloured Brown or Red.

Before retting the mains plug cover, check that there are no cut or stray strands of

wire inside the mains plug. Only BSI or ASTA approved 13 Amp BS1362 fuses should

be used. If you are in any way unsure which mains plug or fuse to use, always refer to

a qualied electrician.

Note: After replacing or changing a fuse on a moulded mains plug which has a fuse

cover, the cover must be retted to the mains plug, the appliance must not be used

without a fuse cover. If lost, replacement fuse covers can be obtained from an

electrical shop.

GB - 2 GB - 3

GB - 4

Keeping the cord tidy

Extend the mains cable in the kettle stand to the

required length. Locate the mains cable in the slot

of the stand. For safety it is recommended that the

length of exposed mains cable is kept as short as

possible. Place the kettle stand on a rm level

surface and plug in the mains plug at a standard

mains socket (240 Volt 13 Amp rated).

Caution. This kettle must only be used with the

stand provided.

Before using your kettle for the First Time

Clean your kettle by boiling a full kettle of water twice and then discarding the

water.

Filling the kettle

Pull and open the lid and ll the kettle with the

required amount of water. Do not exceed

the maximum ll level (Max 1.7L) and not less

than the minimum ll level (Min 0.6L) as indicated

outside the kettle.

Caution. If the kettle is overfilled, boiling water

may be ejected from the spout and cause

scalding.

Switching on

Place the kettle on the stand and press the power

switch to the ON position (indicated by the symbol

‘I’). The indicator on the inside of the kettle will light

up to indicate that the kettle is heating.

Caution. Never open the lid while the water is

boiling. The steam coming out from the kettle is

very hot.

Caution. If there is insufficient water in the kettle,

the automatic safety cut-off will operate. If this

happens, allow the kettle to cool for ten minutes

before refilling with cold water and re-boiling.

When the water has boiled

The kettle will automatically switch o (indicated by

the symbol ‘0’ ).

Caution. Ensure that the switch is not obstructed

and the lid is firmly closed. The kettle will not turn

off if the switch is obstructed or if the lid is open.

Caution. After removing the kettle, there may be

some water on the surface of the stand. This is

condensation from the steam that causes the

kettle to automatically switch off after boiling. This

is normal and should not be a cause for alarm.

Cleaning the kettle

The kettle exterior should be cleaned with a soft damp cloth. Do not use abrasive

cleaners or scouring pads which may damage the nish of the kettle.

Never immerse the kettle or kettle stand in water and always keep the electrical

contacts dry. Disconnect from the mains before cleaning the kettle stand.

Caution. Do not insert any foreign objects or allow any liquid to spill into the Power

Connector Hole.

Descaling the kettle

To descale, ll the kettle with distilled water

up to three-quarters of the Max level and

bring the water to boil. After the kettle has

switched o, add a descaling solution

following the manufacturers instructions.

Never attempt to descale the kettle by

chipping or scraping with a sharp

implement.

Depending on the hardness of the water

in your area, limescale may be deposited

on the heating element and the inside of

the kettle. This normal build-up is not

harmful to health but an excessive amount

of scale may aect the performance of the

kettle.

Power Connector Hole

Electrical Information

CONNECT GREEN AND YELLOW TO EARTH (E)

CONNECT

BLUE TO

NEUTRAL (N)

MAKE SURE THE OUTER

SHEATH OF THE MAINS

CABLE IS SECURELY HELD

BY THE CLAMP

CONNECT

BROWN TO

LIVE (L)

13 AMP FUSE

Cleaning the removable scale filter

To prevent loose particles of limescale being

poured into your beverage, your kettle is tted

with a scale lter. You may remove the lter and

t it back in after cleaning.

To t in the lter, open the lid, place the lter

inside the bracket at the spout and push it down

till it ts in place.

To remove the lter, open the lid, lift up the lter

from the bracket at the spout.

Carlton C17JKW09_p2_060709.pdf 2009/7/6 下午 08:02:58

Rating

Let us know what you think about the Carlton C17JKS09 Kettle by leaving a product rating. Want to share your experiences with this product or ask a question? Please leave a comment at the bottom of the page.

Are you satisfied with the Carlton C17JKS09 Kettle?
Yes No

Be the first to rate this product

0 votes

Join the conversation about this product

Here you can share what you think about the Carlton C17JKS09 Kettle. If you have a question, first carefully read the manual. Requesting a manual can be done by using our contact form.

More about this manual

We understand that it’s nice to have a paper manual for your Carlton C17JKS09 Kettle. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Carlton. They might be able to provide an original manual. Are you looking for the manual of your Carlton C17JKS09 Kettle in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

Brand	Carlton
Model	C17JKS09
Category	Kettles
File type	PDF
File size	1.66 MB

All manuals for Carlton Kettles
More manuals of Kettles

Frequently Asked Questions about Carlton C17JKS09 Kettle

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

What is the sieve for in my kettle? Verified

This is to catch any loose limescale that might have accumulated over time.

This was helpful (401) Read more

The kettle does not finish and keeps on boiling, what should I do? Verified

In many cases the lid of the kettle was not closed properly. If heat is allowed to escape, the kettle will keep on boiling. If this does not solve the problem you should contact the manufacturer or a mechanic.

This was helpful (265) Read more

Can I boil less than the minimim amount of water? Verified

No. When boiling less than the minimum amount of water, the temperature sensor might malfunction. This might prevent the kettle from switching off at boiling point, resulting in possibly dangerous situations.

This was helpful (116) Read more

Is it efficient to fill a kettle with hot water from the faucet? Verified

No. To get warm water to the faucet it is often needed to let cold water out first, which will be wasted. Also, the pipes will fill the same amount of hot water which will not be used and will cool, which leads to energy loss. Therefor it is better to fill a kettle with cold water.

This was helpful (75) Read more