Manual Cordo CRD 4 Cycling Computer

Manual

Totaal afstand

• MODE indrukken tot (Totaal-afstand) verschijnt.

• Achterzijde: SET 3 sec indrukken ( knippert).

• Met MODE cijfers instellen.

• Met SET bevestigen enz.

• Met MODE getallen instellen. Na het laatste cijfer met SET bevestigen.

Total distance

• Press MODE until (total distance) appears.

• Press SET on the back for 3 sec ( flashes).

• Enter number with MODE.

• Confirm with SET and go to the next position.

• Enter next number with MODE. Confirm and quit with SET after the last position.

1 0 0 3 7

1 0 0 3 7

1 2 ...8 ...0

Reset de Display

• MODE langer dan 1 seconde ingedrukt houden.

• Melding knippert. Na 2,5 seconde wordt

(Dagafstand) en (Rit-tijd) teruggezet op 0.

Reset the displays

• Keep MODE pressed down for longer than 1 second.

•Display flashes. After 2.5 seconds

(Trip distance) and (Ride time) are reset to 0.

Algemene opmerkingen

Batterij: 1 Lithium type 2032.3V. Wissel de batterijen na 3 jaar of eerder als de

batterijen zwakker worden. Batterijdeksel met munt openen.

Batterijen wisselen:

• Voor het wisselen van de batterijen noteer de wielomtrek en de Totaalafstand.

• Let op Plus en Min, bij het afnemen van de deksel moet de Plus van de batterij

zichtbaar zijn.

• Dichtingsring goed plaatsen.

• Na het verwisselen van de batterijen moeten de Totaalafstand, de Wielomtrek en Klok

opnieuw worden ingesteld. De display gaat automatisch naar instelling van de Taal

en Wielomtrek.

Garantie: Hier gelden de voorgeschreven garantie bepalingen.

General remarks

Battery: 1 lithium type 2032, 3V. Change batteries after appr. 3 years or as soon as the

display fades. Open the battery compartment cover with a coin.

Changing batteries:

• Before changing take note of wheel size and total distance.

• Observe plus and minus. When battery compartment is open, you should see the

plus pole!

• Refit rubber seal if detached.

• After change of batteries total distance, wheel size and clock must be re-entered.

Set language is shown as first value on the display.

Warranty: The legal warranty regulations are valid.

Probleemoplossingen

KMH geen display aanduiding

• Metaal huls over de magneet geschoven? (beeld 9)

• Is de wielomtrek goed ingesteld?

• Is de computer goed in de houder bevestigd?

• Oxidatie van batterijen of contacten?

• Kabelbreuk ?

• Afstand magneet en sensor oké (max 5 mm)

• Is de magneet nog gemagnetiseerd?

Display geen beeld

• Batterij in orde?

• Batterij goed gemonteerd? Opletten! Plus/Min

• Batterij contacten oké? Zonodig voorzichtig bijbuigen

KMH klopt niet

• 2 magneten gemonteerd?

• Magneet goed gemonteerd?

• Wielomtrek goed ingesteld?

Display zwart

• Alleen bij directe zonnestraling >60°C. Bij afkoeling weer normaal!

Display traag

• Alleen bij temperaturen onder de 0°C. Bij hogere tempuren normaal beeld!

Problem solutions

No speed display

• Safety shell is pushed over the magnet (fig. 9)?

• Is the entered wheel size correct?

• Is the computer properly placed in the bracket?

• Did you check the contacts for oxidation/corrosion?

• Check the cable for damage.

• Did you check the distance? (max. 5 mm/0,2 inch)

• Is the magnet magnetizised?

Display is empty

• Check the battery

• Did you put the battery in the right way? (pay attention to plus and minus)

• Check contacts, bend if necessary

KMH display is wrong

• Did you assemble 2 magnets?

• Is the magnet positioned in the right way?

• Did you enter the correct wheel size?

Display is black

• Only in direct sunlight (>60°C), under 60°C the display will return to normal.

Display is sluggish

• Only at temperatures under 0°C, display will be normal after warm up.

Instellen van de klok

• Druk op MODE tot (KLOK) verschijnt

• Aan de achterzijde SET 3 sec ingedrukt houden.

• Met MODE uren instellen.

• Met MODE van uren naar minuten wisselen.

• Met RESET minuten instellen en met SET bevestigen, instel modus verlaten.

Set clock

• Press MODE until (CLOCK) appears.

• Press SET on the back for 3 sec. with a pointed tool.

• Enter the hours with MODE.

• Confirm with SET and go to minutes.

• Enter minutes with MODE. Confirm and quit with SET.

www.cordo.nl

Cordo is de lijn fietsaccessoires van AGU BV, Alkmaar - Nederland

Rating

More about this manual

We understand that it’s nice to have a paper manual for your Cordo CRD 4 Cycling Computer. You can always download the manual from our website and print it yourself. If you would like to have an original manual, we recommend you contact Cordo. They might be able to provide an original manual. Are you looking for the manual of your Cordo CRD 4 Cycling Computer in a different language? Choose your preferred language on our homepage and search for the model number to see if we have it available.

Specifications

All manuals for Cordo Cycling Computers
More manuals of Cycling Computers

Frequently Asked Questions about Cordo CRD 4 Cycling Computer

Our support team searches for useful product information and answers to frequently asked questions. If you find an inaccuracy in our frequently asked questions, please let us know by using our contact form.

Related products

Manual

Cordo FB10i Cycling Computer

Manual

Cordo CRD 10 Cycling Computer

Manual

Cordo CRD S Cycling Computer

Manual

Cordo FB6 Cycling Computer

Manual

Cordo FB9 Cycling Computer

Manual

Cordo CRD 7 Cycling Computer

Manual

Sigma ROX 2.0 Cycling Computer

Manual

Garmin Edge Explore 2 Cycling Computer

Related categories